Updated Fortinet NSE4 exam questions and NSE4 braindumps from Dumpslabs.com. Pass the NSE4 exam with our NSE4 VCE dumps. Start NSE4 Exam Now.
2024 Fortinet Official New Released NSE4 Q&As
100% Free Download! 100% Pass Guaranteed!
https://www.certleader.com/NSE4-dumps.html
Q1. - (Topic 5) Regarding tunnel-mode SSL VPN, which three statements are correct? (Choose three.) A. Split tunneling is supported. B. It requires the installation of a VPN client. C. It requires the use of an Internet browser. D. It does not support traffic from third-party network applications. E. An SSL VPN IP address is dynamically assigned to the client by the FortiGate unit. View Ans
Q1. - (Topic 20) Examine at the output below from the diagnose sys top command: # diagnose sys top 1 Run Time: 11 days, 3 hours and 29 minutes 0U, 0N, 1S, 99I; 971T, 528F, 160KF sshd 123 S 1.9 1.2 ipsengine 61 S < 0.0 5.2 miglogd 45 S 0.0 4.9 pyfcgid 75 S 0.0 4.5 pyfcgid 73 S 0.0 3.9 Which statements are true regarding the output above? (Choose two.) A. The sshd process is the one consumi
Q1. - (Topic 15) Review the IKE debug output for IPsec shown in the exhibit below. Which statements is correct regarding this output? A. The output is a phase 1 negotiation. B. The output is a phase 2 negotiation. C. The output captures the dead peer detection messages. D. The output captures the dead gateway detection packets. View AnswerAnswer: C Q2. - (Topic 16) Which statement corr
Q1. - (Topic 4) Which statement regarding the firewall policy authentication timeout is true? A. It is an idle timeout. The FortiGate considers a user to be “idle” if it does not see any packets coming from the user’s source IP. B. It is a hard timeout. The FortiGate removes the temporary policy for a user’s source IP address after this timer has expired. C. It is an idle timeout. The
Q1. - (Topic 4) The FortiGate port1 is connected to the Internet. The FortiGate port2 is connected to the internal network. Examine the firewall configuration shown in the exhibit; then answer the question below. Based on the firewall configuration illustrated in the exhibit, which statement is correct? A. A user that has not authenticated can access the Internet using any protocol that does n
Q1. - (Topic 22) Which IP packets can be hardware-accelerated by a NP6 processor? (Choose two.) A. Fragmented packet. B. Multicast packet. C. SCTP packet. D. GRE packet. View AnswerAnswer: B,C Q2. - (Topic 11) Examine the exhibit; then answer the question below. The Vancouver FortiGate initially had the following information in its routing table: S 172.20.0.0/16 [10/0] via 172.21.1.2,
Q1. - (Topic 15) Review the configuration for FortiClient IPsec shown in the exhibit. Which statement is correct regarding this configuration? A. The connecting VPN client will install a route to a destination corresponding to the student_internal address object. B. The connecting VPN client will install a default route. C. The connecting VPN client will install a route to the 172.20.1.[1-5]
Q1. - (Topic 6) You are the administrator in charge of a FortiGate acting as an IPsec VPN gateway using route-based mode. Users from either side must be able to initiate new sessions. There is only 1 subnet at either end and the FortiGate already has a default route. Which two configuration steps are required to achieve these objectives? (Choose two.) A. Create one firewall policy. B. Create
Q1. - (Topic 15) Which statements are correct properties of a partial mesh VPN deployment. (Choose two.) A. VPN tunnels interconnect between every single location. B. VPN tunnels are not configured between every single location. C. Some locations are reached via a hub location. D. There are no hub locations in a partial mesh. View AnswerAnswer: B,C Q2. - (Topic 15) Review the configurat
Q1. - (Topic 21) Which statements are correct regarding an IPv6 over IPv4 IPsec configuration? (Choose two.) A. The source quick mode selector must be an IPv4 address. B. The destination quick mode selector must be an IPv6 address. C. The Local Gateway IP must be an IPv4 address. D. The remote gateway IP must be an IPv6 address. View AnswerAnswer: B,C Q2. - (Topic 14) Two devices are in
Q1. - (Topic 5) A user logs into a SSL VPN portal and activates the tunnel mode. The administrator has enabled split tunneling. The exhibit shows the firewall policy configuration: Which static route is automatically added to the client’s routing table when the tunnel mode is activated? A. A route to a destination subnet matching the Internal_Servers address object. B. A route to the destin
Q1. - (Topic 11) Examine the static route configuration shown below; then answer the question following it. config router static edit 1 set dst 172.20.1.0 255.255.255.0 set device port1 set gateway 172.11.12.1 set distance 10 set weight 5 next edit 2 set dst 172.20.1.0 255.255.255.0 set blackhole enable set distance 5 set weight 10 next end Which of the following statements correctly describes t
Q1. - (Topic 17) With FSSO, a domain user could authenticate either against the domain controller running the collector agent and domain controller agent, or a domain controller running only the domain controller agent. If you attempt to authenticate with a domain controller running only the domain controller agent, which statements are correct? (Choose two.) A. The login event is sent to the
Q1. - (Topic 7) Which antivirus inspection mode must be used to scan SMTP, FTP, POP3 and SMB protocols? A. Proxy-based. B. DNS-based. C. Flow-based. D. Man-in-the-middle. View AnswerAnswer: C Q2. - (Topic 15) Which statement is an advantage of using a hub and spoke IPsec VPN configuration instead of a fully-meshed set of IPsec tunnels? A. Using a hub and spoke topology provides full r