Q1. What is the correct path to verify the Overall Status of Chassis 1 | Server 3?
A. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 Status tab
B. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
C. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 FSM tab
D. Servers Tab > Chassis > Server 3 General tab
E. Status Tab > Chassis > Chassis 1 > Servers > Server 3
F. Admin Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
Answer: B
Q2. Refer to the exhibit.
Which option should you select to get the output of the show tech-support detail command for the Cisco UCS B-Series blade?
A. A - ucsm
B. B - chassis
C. C - fabric-extender
D. D - rack-server
Answer: B
Q3. Refer to the exhibit.
Where is the best place to see whether the system is ready for a Fabric Interconnect failover?
A. A - Overall Status operable
B. B - L1 Connection
C. C - Part Details
D. D - Access
E. E - High Availability Details
Answer: E
Q4. Which tool does a network administrator not need when installing hardware?
A. cable tester
B. wrench set
C. cable wraps
D. needle-nose pliers
E. PCMCIA memory
F. soldering iron with grounded tip
Answer: F
Q5. Which type of optics module is supported by a 6-port 40 GE Cisco Nexus 7000 M2 Series I/O module?
A. CPAK
B. QSFP+
C. SFP/SFP+
D. CFP
Answer: B
Q6. Refer to the exhibit.
What is the name of this rack-mount server?
A. Cisco UCS C220 Rack-Mount Server
B. Cisco UCS C240 Rack-Mount Server
C. Cisco UCS C420 Rack-Mount Server
D. Cisco UCS C460 Rack-Mount Server
Answer: C
Q7. Which two Cisco Nexus switches provide the foundation of the Cisco Application Centric Infrastructure? (Choose two.)
A. Cisco Nexus 7718 switch
B. Cisco Nexus 9508 switch
C. Cisco Nexus 7710 switch
D. Cisco Nexus 93128TX switch
E. Cisco Nexus 6004 switch
Answer: B,D
Q8. Which three statements about FCoE are true? (Choose three.)
A. Allows Fibre Channel and Ethernet networks to share a single, integrated infrastructure.
B. Encapsulates Fibre Channel frames into Ethernet frames, which allows them to run alongside traditional IP traffic.
C. Increases capital costs due to the difficulty to manage.
D. Consolidates I/O traffic in the data center.
Answer: A,B,D
Q9. Which two statements about DIMM replacement in Cisco UCS Servers are true? (Choose two.)
A. In blade servers, DIMMs can be installed in either 1, 2, 4, or 8 DIMMs per channel.
B. Rack-mount and blade servers have memory fault LEDs that indicate which DIMM requires attention.
C. In servers that require pairs of DIMMs, the pairs must be identical (manufacturer, size, part #, and so on).
D. If the memory in a server is not fully populated, you can install DIMMs in any open slot.
Answer: A,C
Q10. Which two statements about PCIe are true? (Choose two.)
A. The PCIe link is built around dedicated unidirectional couples of serial, point-to-point connections known as lanes.
B. You can install a PCI Express x8 adapter into an x4 slot.
C. The PCIe standard is a bus-based system in which all the devices share the same bidirectional, 32-bit or 64-bit, parallel signal path.
D. The PCIe 1.0 standard doubles the transfer rate compared to PCIe 2.0.
E. A link that is composed of four lanes is called an x4 link.
Answer: A,E