Q1. Which of the following is not a policy type available on the CMC appliance?
A. Optimization policy
B. SDR policy
C. Security Policy
D. Networking policy
Answer: B
Q2. Which of the following interfaces can be configured using the configuration wizard?
A. Primary only
B. Primary and inpath0_0
C. Inpath0_0 only
D. Primary and auxiliary
Answer: B
Q3. What are the primary requirements that must be considered when sizing a Steelhead appliance for a customer? (Select 4)
A. Optimized WAN throughput
B. Connection count
C. Datastore size
D. Bypass port count
E. Speed / duplex requirements
Answer: ABCD
Q4. To ensure peak operational performance, it is recommended that the Steelhead appliance be rebooted:
A. Once every week
B. Once every month
C. Rebooting the Steelhead appliance is not recommended as a performance enhancing maintenance activity
D. Rebooting the Steelhead appliance is not recommended because all network activity stops until it comes back
Answer: C
Q5. How many TCP connections can an Interceptor appliance set up per second?
A. 1000
B. 2000
C. 3000
D. 4000
E. 5000 or over
Answer: E
Q6. What WAN traffic problems do Steelhead appliances overcome? (Select 3)
A. Number of connections per second
B. Data deduplication
C. Bandwidth
D. Latency
E. TCP window size
F. Optimization
Answer: CDE
Q7. When implementing PBR, a Steelhead appliance is connected to the router using which Steelhead appliance interface?
A. lan0_0
B. wan0_0
C. Primary
D. AUX
E. Remote
Answer: B
Q8. When deploying a Steelhead appliance server-side out-of-path in the data center, what will be the source IP address seen by the destination server in the data center?
A. The client PC's IP address
B. The client-side Steelhead appliance's Primary IP address
C. The client-side Steelhead appliance's In-path IP address D. The server-side Steelhead appliance's Primary IP address
Answer: D
Q9. How many in-path rules will a WAN-initiated single connection execute on a Steelhead appliance?
A. 0
B. 1
C. 2
D. 3
Answer: A
Q10. Assume the SSL server is configured for the default SSL port. Which port has to be specified in the in-path rules of the client-side Steelhead appliance?
A. 443
B. 445
C. 7801
D. 8080
Answer: A