Q1. What default DNS entry is required for CMC touchless auto-configuration?
A. riverbedcmc
B. cmcsteelhead
C. cmcriverbed
D. steelheadcmc
Answer: A
Q2. Which of the following factors are important to consider when sizing a Steelhead appliance? (Select 3)
A. Number of simultaneous optimized connections
B. The maximum optimized WAN bandwidth
C. The size of datastore
D. The number of applications used by the enterprise
Answer: ABC
Q3. What is the maximum datastore size?
A. 15 MB
B. 5 GB
C. 20 GB
D. 10 TB
E. 50 TB
Answer: C
Q4. When implementing WCCP, Riverbed recommends using which service groups?
A. 61 and 62
B. 69 and 70
C. 100 and 101
D. 101 and 102
E. 102 and 103
Answer: A
Q5. What is the default WAN visibility mode?
A. Correct Addressing
B. Port Transparency
C. Full Addressing
D. Full Transparency
E. Transparency
Answer: A
Q6. Which two parameters are required when configuring a fixed-target rule?
A. The target IP address and subnet mask of the target Steelhead appliance
B. The TCP option number for auto-discovery
C. The target Steelhead appliance and destination port number
D. The source IP address and source port number of the client traffic
Answer: C
Q7. What are valid WAN visibility modes of the Steelhead appliance? (Select 3)
A. Correct Addressing
B. Port Transparency
C. Full Addressing
D. Full Transparency
E. Transparency
Answer: ABD
Q8. Which trunking protocols are supported by the Steelhead appliance?
A. 802.1Q
B. 802.1P
C. 802.1AD
D. Dynamic Etherchannel
Answer: A
Q9. When upgrading a Steelhead appliance from the Management Console, the new image is always installed on the:
A. Booted partition
B. Backup partition
C. Both the boot and backup partitions
D. The image is only installed into a partition after a reboot (from a temporary location)
E. Upgrades can only be done from the CLI
Answer: B
Q10. What effect will enable SDR-M (Scalable Data Referencing Memory) have on a Steelhead appliance in production?
A. An increase in overall LAN throughput
B. SDR would occur in RAM until flushed to disk
C. An increase in overall WAN throughput
D. SDR would occur on disk and backed up to RAM for future lookups
E. SDR must occur over the primary interface directly to RAM
Answer: A