156-915.80 Exam - Check Point Certified Security Expert Update - R80

Question No: 8

Fill in the blank.

In Load Sharing Unicast mode, the internal cluster IP address is 10.4.8.3. The internal interfaces on two members are 10.4.8.1 and 10.4.8.2. Internal host 10.4.8.108 Pings 10.4.8.3, and receives replies. The following is the ARP table from the internal Windows host 10.4.8.108. Review the exhibit and type the IP address of the member serving as the pivot machine in the space below.

View Answer

Question No: 9

MegaCorp is running Smartcenter R70, some Gateways at R65 and some other Gateways with R60. Management wants to upgrade to the most comprehensive IPv6 support. What should the administrator do first?

A. Upgrade Smartcenter to R80 first.

B. Upgrade R60-Gateways to R65.

C. Upgrade every unit directly to R80.

D. Check the ReleaseNotes to verify that every step is supported.

View Answer

Question No: 10

Can you implement a complete IPv6 deployment without IPv4 addresses?

A. No. SmartCenter cannot be accessed from everywhere on the Internet.

B. Yes. Only one TCP stack (IPv6 or IPv4) can be used at the same time.

C. Yes, There is no requirement for managing IPv4 addresses.

D. No. IPv4 addresses are required for management.

View Answer

Question No: 11

The Identity Agent is a lightweight endpoint agent that authenticates securely with Single Sign-On (SSO). What is not a recommended usage of this method?

A. When accuracy in detecting identity is crucial

B. Leveraging identity for Data Center protection

C. Protecting highly sensitive servers

D. Identity based enforcement for non-AD users (non-Windows and guest users)

View Answer

Question No: 12

Which of the following is a CLI command for Security Gateway R80?

A. fw tab -u

B. fw shutdown

C. fw merge

D. fwm policy_print <policyname>

View Answer

Question No: 13

Looking at the SYN packets in the Wireshark output, select the statement that is true about NAT.

A. This is an example of Hide NAT.

B. There is not enough information provided in the Wireshark capture to determine the NAT settings.

C. This is an example of Static NAT and Translate destination on client side unchecked in Global Properties.

D. This is an example of Static NAT and Translate destination on client side checked in Global Properties.

View Answer

Question No: 14

Which Check Point address translation method is necessary if you want to connect from a host on the Internet via HTTP to a server with a reserved (RFC 1918) IP address on your DMZ?

A. Dynamic Source Address Translation

B. Hide Address Translation

C. Port Address Translation

D. Static Destination Address Translation

View Answer

Question No: 15

In the following cluster configuration; if you reboot sglondon_1 which device will be active when sglondon_1 is back up and running? Why?

A. sglondon_1 because it the first configured object with the lowest IP.

B. sglondon_2 because sglondon_1 has highest IP.

C. sglondon_1, because it is up again, sglondon_2 took over during reboot.

D. sglondon_2 because it has highest priority.

View Answer

Question No: 16

Which process should you debug if SmartDashboard login fails?

A. sdm

B. cpd

C. fwd

D. fwm

View Answer

Question No: 17

Type the command and syntax you would use to verify that your Check Point cluster is functioning correctly.

View Answer