P.S. Guaranteed 200-125 class are available on Google Drive, GET MORE: https://drive.google.com/open?id=1jQmx5oxI6Dh5yoCIPQpEra2L4K5UYNUa
New Cisco 200-125 Exam Dumps Collection (Question 5 - Question 14)
Q5. Which two EtherChannel PAgP modes can you configure? (Choose two.)
A. passive
B. auto
C. desirable
D. on
E. active
Answer: B,C
Q6. Which statement about LLDP is true?
A. It is a Cisco proprietary protocol.
B. It is configured in global configuration mode.
C. The LLDP update frequency is a fixed value.
D. It runs over the transport layer.
Answer: B
Q7. Which type of address is the public IP address of a NAT device?
A. outside global
B. outside local
C. inside global
D. inside local
E. outside public
F. inside public
Answer: C
Q8. Refer to the exhibit.
Which user-mode password has just been set?
A. Telnet
B. Auxiliary
C. SSH
D. Console
Answer: A
Q9. Which switching method duplicates the first six bytes of a frame before making a switching decision?
A. fragment-free switching
B. store and-forward switching
C. cut through switching
D. ASIC switching
Answer: C
Explanation: Cut and Through method has lowest latency. In this method Switch only read first six bytes from frame after the preamble. These six bytes are the destination address of frame. This is the fastest method of switching. This method also processes invalid frames. Only advantage of this method is speed.
Q10. In which three ways is an IPv6 header simpler than an IPv4 header? (Choose three.)
A. Unlike IPv4 headers, IPv6 headers have a fixed length.
B. IPv6 uses an extension header instead of the IPv4 Fragmentation field.
C. IPv6 headers eliminate the IPv4 Checksum field.
D. IPv6 headers use the Fragment Offset field in place of the IPv4 Fragmentation field.
E. IPv6 headers use a smaller Option field size than IPv4 headers.
F. IPv6 headers use a 4-bit TTL field, and IPv4 headers use an 8-bit TTL field.
Answer: A,B,C
Q11. Which two pieces of information are provided by the show controllers serial 0 command? (Choose two.)
A. the type of cable that is connected to the interface.
B. The uptime of the interface
C. the status of the physical layer of the interface
D. the full configuration of the interface
E. the interface's duplex settings
Answer: A,C
Explanation:
Theshow controllercommand provides hardware-related information useful to troubleshoot and diagnose issues with Cisco router interfaces. The Cisco 12000 Series uses a distributed architecture with a central command-line interface (CLI) at the Gigabit Route Processor (GRP) and a local CLI at each line card.
Q12. Which option is a valid hostname for a switch?
A. Switch-Cisco
B. Switch-Cisco!
C. SwitchCisco
D. SwitchCisc0
Answer: C
Q13. Which two statements about IPv6 router advertisement messages are true? (Choose two.)
A. They use ICMPv6 type 134.
B. The advertised prefix length must be 64 bits.
C. The advertised prefix length must be 48 bits.
D. They are sourced from the configured IPv6 interface address.
E. Their destination is always the link-local address of the neighboring node.
Answer: A,B
Q14. Which two steps must you perform to enable router-on-a-stick on a switch? (Choose two.)
A. Configure an IP route to the VLAN destination network.
B. Connect the Router to a trunk port.
C. Configure full duplex.
D. Configure the subinterface number exactly the same as the matching VLAN.
E. Assign the access port to a VLAN.
Answer: B,C
Recommend!! Get the Guaranteed 200-125 dumps in VCE and PDF From Examcollection, Welcome to download: http://www.examcollectionuk.com/200-125-vce-download.html (New 890 Q&As Version)