200-125 Exam - CCNA Cisco Certified Network Associate CCNA (v3.0)

certleader.com

P.S. Real 200-125 guidance are available on Google Drive, GET MORE: https://drive.google.com/open?id=1tmPuPMdbI90mJvs8j7thMAwqkALcwK_i


New Cisco 200-125 Exam Dumps Collection (Question 15 - Question 24)

Q15. Refer to the exhibit.

IF R1 sends traffic to 192.168.101.45 the traffic is sent through which interface?

A. FastEthernet0/1

B. FastEthernet0/0

C. FastEthernet1/0

D. FastEthernet1/1

Answer: D


Q16. What is the benefit of point-to-point leased line ?

A. Low cost

B. Full-mesh capability

C. Flexibillity of design

D. Simply configuration

Answer: D


Q17. Which type of cable must you use to connect two device with mdi interfaces ?

A. rolled

B. crosseover

C. crossed

D. straight through

Answer: B


Q18. Under which circumstance is a router on a stick most appropriate?

A. When the router must route a single across multiple physical links.

B. When the router must route multiple subnets across multiple physical links.

C. When the router must route a single across single physical links.

D. When the router must route multiple subnets across single physical links.

Answer: D


Q19. Which process is associated with spanning-tree convergence?

A. determining the path cost

B. electing designated ports

C. learning the sender bridge ID

D. assigning the port ID

Answer: B

Explanation:

Spanning Tree Protocol (STP) convergence (Layer 2 convergence) happens when bridges and switches have transitioned to either the forwarding or blocking state. When layer 2 is converged, Root Switch is elected andRoot Ports,Designated PortsandNon-Designated portsin all switches are selected. At Converged condition, theRoot Portsand the Designated ports are in forwarding state, and all other ports are in blocking state.


Q20. Which command can you enter to determine the addresses that have been assigned on a DHCP Server?

A. Show ip DHCP database.

B. Show ip DHCP pool.

C. Show ip DHCP binding.

D. Show ip DHCP server statistic.

Answer: C

Explanation: Reference: http://www.aubrett.com/InformationTechnology/RoutingandSwitching/Cisco/CiscoRouters/DHCPBindings.aspx

u201cRouter#show ip dhcp binding

Bindings from all pools not associated with VRF: IP address Client-ID/ Lease expiration Type

10.16.173.0 24d9.2141.0ddd Jan 12 2013 03:42 AM Automaticu201d


Q21. which major ipv6 address type is supported in ipv4 but rarely used ?

A. Broadcast

B. multicast

C. unicast

D. anycast

Answer: D


Q22. which feature must you enable to distribute vlans automatically across multiple switch ?

A. configure NTP

B. Configure the native VLAN

C. Define Each vlan

D. configure VTP

Answer: D


Q23. Which mode is compatible with Trunk, Access, and desirable ports?

A. Trunk Ports

B. Access Ports

C. Dynamic Auto

D. Dynamic Desirable

Answer: C

Explanation:

The 'dynamic auto' will configure the port to accept incoming negotiation and will accept becoming either a trunk or an access port. Dynamic Auto allows the port to negotiate DTP (Dynamic Trunking Protocol) if the other side is set to trunk or desirable. Otherwise it will become an access port.


Q24. Which Two options are features of the extended ping command ?

A. it can send packets from a specified interface or ip address

B. it can resolve the destination host name

C. it can ping multiple hosts at the same time

D. it can count the number of hops to the remote host

E. it can send a specified number of packets

Answer: A,E


100% Abreast of the times Cisco 200-125 Questions & Answers shared by Certleader, Get HERE: https://www.certleader.com/200-125-dumps.html (New 889 Q&As)