We provide which are the best for clearing 200-150 test, and to get certified by Cisco DCICN Introducing Cisco Data Center Networking. The covers all the knowledge points of the real 200-150 exam. Crack your Cisco 200-150 Exam with latest dumps, guaranteed!
Online Cisco 200-150 free dumps demo Below:
NEW QUESTION 1
What is the maximum distance that is supported by Cisco passive Twinax cables?
- A. 5m
- B. 3m
- C. 4m
- D. 10m
Answer: A
NEW QUESTION 2
Which premise-based conferencing solution supports Skype for Business and WebRTC?
- A. Telepresence Server
- B. Cisco Meeting Server
- C. Spark
- D. Cisco WebEx
Answer: B
NEW QUESTION 3
Which two protocols can you use SAN storage that is accesses via low-latency, high-bandwidth networking?
(Choose two.)
- A. AFP
- B. CIFS
- C. NFS
- D. FCP
- E. iSCSI
Answer: BC
NEW QUESTION 4
Refer to the exhibit.
Which description of this core-edge topology is true?
- A. The single-hop design provides minimal latency because the storage devices and the hosts connect to the same switch.
- B. The single-hop design from the host to the target provides a highly scalable solution.
- C. A single core switch connects the storage devices and the hosts.
- D. The hosts connect to an edge device, which is connect to the core.
Answer: D
NEW QUESTION 5
Which Cisco videophones can be registered to Spark?
- A. 8845
- B. 8945
- C. 9971
- D. 7961
Answer: A
NEW QUESTION 6
Which protocol is used to encapsulate Fibre Channel frames, enabling them to be transmitted over Ethernet networks?
- A. FCoE
- B. DCB
- C. SCSI
- D. Ethernet SAN
Answer: A
NEW QUESTION 7
Refer to the exhibit.
Which description of the configuration is true?
- A. Host 10.1.1.1.2 in the network operator group.
- B. Host 10.1.1.1.2 can access both communities
- C. Host 10.1.1.1 can access the ABC community only.
- D. Host 10.1.1.1 can access both communities.
Answer: D
NEW QUESTION 8
Which command set creates an access control list on a Cisco Nexus switch to deny only FTP traffic from any source to destination host 10.10.10.110?
- A. N5K-A(config)# Ip access-list 101N5K-A(config-acl)# deny judp any host 10.10.1.110. eq 21 N5K-A(config-acl)# permit ip any any
- B. N5K-A(config)# Ip access-list 101N5K-A(config-acl)# deny judp any host 10.10.1.110. eq ftp
- C. N5K-A(config)# deny tcp any host 10.10.1.110. eq ftpN5K-A(config)# access-list 101deny Ip any any
- D. N5K-A(config)# Ip access-list 101N5K-A(config-acl)# deny tcp any host 10.10.1.110. eq 21 N5K-A(config-acl)# permit Ip any any
Answer: D
NEW QUESTION 9
Ethernet 1/1 is assigned IP address 10.1.1.1 with subnet mask 255.255.255.0. Which configuration is used to configure EIGRP on a Cisco Nexus 7000 switch?
- A. feature eigrp!interface Ethernet1/1ip address 10.1.1.1 255.255.255.0no shutdown!router eigrp 1network 10.1.1.0 0.0.0.255
- B. feature eigrp!router eigrp 1autonomous-system 1!interface Ethernet1/1ip address 10.1.1.1/24ip router eigrp 1no shutdown
- C. router eigrp 1autonomous-system 1!interface Ethernet1/1ip address 10.1.1.1/24ip router eigrp 1no shutdown
- D. feature eigrp!interface Ethernet1/1ip address 10.1.1.1/24no shutdown!router eigrp 1network 10.1.1.0 0.0.0.255
Answer: B
NEW QUESTION 10
Which two protocols are associated with the link layer of the OSI reference model? (Choose two)
- A. VTP
- B. SSH
- C. CDP
- D. BGP
- E. DNS
Answer: BD
NEW QUESTION 11
Which two addresses represent multicast addresses? (Choose two.)
- A. 224.1.47.5
- B. 240.100.22.3
- C. FF05::1
- D. 2001::1
Answer: AC
NEW QUESTION 12
Which reason for configuring a Cisco Nexus 5000 Series switch in NPV mode is valid?
- A. to increase the domain ID limit by assigning subdomain IDs to the edge switches
- B. to share all the domain IDs with the core and edge switches
- C. to eliminate the domain ID limit by assigning a different domain ID to the core switch
- D. to alleviate the domain ID limit by sharing the domain ID with the edge switches
Answer: C
NEW QUESTION 13
Drag and drop the Ethernet UTP cable category on the left to the correct description on the right.
Answer:
Explanation: 
NEW QUESTION 14
Which four statements indicate unique properties of VLAN 1 on Cisco Nexus switches? (Choose four.)
- A. VLAN 1 is used to flood multicast traffic.
- B. VLAN 1 cannot be deleted.
- C. VLAN 1 is used for Cisco Discovery Protocol.
- D. VLAN 1 is used for VTP advertisements.
- E. VLAN 1 defines a collision domain.
- F. VLAN 1 defines a broadcast domain.
Answer: BCDF
Explanation: http://www.cisco.com/en/US/docs/switches/datacenter/sw/5_x/nx-os/layer2/configuration/guide/Cisco_Nexus_7
NEW QUESTION 15
In a Resident and Scalable Meeting Servers solution where should TURN Servers be configured?
- A. CMS Edge
- B. CMS Core
- C. UCM Server
- D. TelePresence Server
Answer: A
NEW QUESTION 16
Which Cisco WebEX product can be integrated in a CMR Cloud or CMR Hybrid deployment?
- A. Cisco WebEx Support Center
- B. Cisco WebEx Event Center
- C. Cisco WebEx Center
- D. Cisco WebEx Meeting Center
Answer: D
100% Valid and Newest Version 200-150 Questions & Answers shared by Certleader, Get Full Dumps HERE: https://www.certleader.com/200-150-dumps.html (New 177 Q&As)