200-301 Exam - Cisco Certified Network Associate

NEW QUESTION 1
How does HSRP provide first hop redundancy?

• A. It load-balances traffic by assigning the same metric value to more than one route to the same destination m the IP routing table.
• B. It load-balances Layer 2 traffic along the path by flooding traffic out all interfaces configured with the same VLAN.
• C. It forwards multiple packets to the same destination over different routed links n the data path
• D. It uses a shared virtual IMC and a virtual IP address to a group of routers that serve as the default gateway for hosts on a LAN

Answer: C

NEW QUESTION 2
A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented? (Choose two)

• A. runts
• B. giants
• C. frame
• D. CRC
• E. input errors

Answer: DE

NEW QUESTION 3
Which design element is a best practice when deploying an 802.11b wireless infrastructure?

• A. disabling TPC so that access points can negotiate signal levels with their attached wireless devices.
• B. setting the maximum data rate to 54 Mbps on the Cisco Wireless LAN Controller
• C. allocating nonoverlapping channels to access points that are in close physical proximity to one another
• D. configuring access points to provide clients with a maximum of 5 Mbps

Answer: C

NEW QUESTION 4
Refer to the exhibit.

If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10.13.0.1 120 command how does the router respond?

• A. It ignores the new static route until the existing OSPF default route is removed
• B. It immediately replaces the existing OSPF route in the routing table with the newly configured static route
• C. It starts load-balancing traffic between the two default routes
• D. It starts sending traffic without a specific matching entry in the routing table to GigabitEthernetO/1

Answer: D

NEW QUESTION 5
Refer to the exhibit.

What is the effect of this configuration?

• A. The switch port interface trust state becomes untrusted
• B. The switch port remains administratively down until the interface is connected to another switch
• C. Dynamic ARP inspection is disabled because the ARP ACL is missing
• D. The switch port remains down until it is configured to trust or untrust incoming packets

Answer: A

NEW QUESTION 6
Which action is taken by a switch port enabled for PoE power classification override?

• A. When a powered device begins drawing power from a PoE switch port a syslog message is generated
• B. As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused
• C. If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects
• D. If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled

Answer: C

NEW QUESTION 7
Which network allows devices to communicate without the need to access the Internet?

• A. 1729.0.0/16
• B. 172.28.0.0/16
• C. 192.0.0.0/8
• D. 209.165.201.0/24

Answer: D

NEW QUESTION 8
Which MAC address is recognized as a VRRP virtual address?

• A. 0000.5E00.010a
• B. 0005.3711.0975
• C. 0000.0C07.AC99
• D. 0007.C070/AB01

Answer: A

NEW QUESTION 9
An engineer configured an OSPF neighbor as a designated router. Which state verifies the designated router is in the proper mode?

• A. Exchange
• B. 2-way
• C. Full
• D. Init

Answer: B

NEW QUESTION 10
Which output displays a JSON data representation?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 11
Refer to the exhibit.

Which command provides this output?

• A. show ip route
• B. show ip interface
• C. show interface
• D. show cdp neighbor

Answer: D

NEW QUESTION 12
Which set of action satisfy the requirement for multifactor authentication?

• A. The user swipes a key fob, then clicks through an email link
• B. The user enters a user name and password, and then clicks a notification in an authentication app on a mobile device
• C. The user enters a PIN into an RSA token, and then enters the displayed RSA key on a login screen
• D. The user enters a user name and password and then re-enters the credentials on a second screen

Answer: A

NEW QUESTION 13

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 14
A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP By default which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?

• A. port-to-multipoint
• B. broadcast
• C. point-to-point
• D. nonbroadcast

Answer: C

NEW QUESTION 15
A router running EIGRP has learned the same route from two different paths Which parameter does the router use to select the best path?

• A. cost
• B. adminstrative distance
• C. metric
• D. as-path

Answer: C

NEW QUESTION 16
Refer to the exhibit.

With which metric was the route to host 172.16.0.202 learned?

• A. 110
• B. 38443
• C. 3184439

Answer: C

NEW QUESTION 17
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?

• A. on
• B. auto
• C. active
• D. desirable

Answer: D

NEW QUESTION 18
Which two actions influence the EIGRP route selection process? (Choose two)

• A. The router calculates the reported distance by multiplying the delay on the exiting Interface by 256.
• B. The router calculates the best backup path to the destination route and assigns it as the feasible successor.
• C. The router calculates the feasible distance of all paths to the destination route
• D. The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link
• E. The router must use the advertised distance as the metric for any given route

Answer: AD

NEW QUESTION 19
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)

• A. Enable NTP authentication.
• B. Verify the time zone.
• C. Disable NTP broadcasts
• D. Specify the IP address of the NTP server
• E. Set the NTP server private key

Answer: DE

NEW QUESTION 20
Refer to the exhibit.

Drag and drop the networking parameters from the left onto the correct values on the right. Check the answer below.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 21
What makes Cisco DNA Center different from traditional network management applications and their management of networks?

• A. It only supports auto-discovery of network elements in a greenfield deployment.
• B. It modular design allows someone to implement different versions to meet the specific needs of an organization
• C. IT abstracts policy from the actual device configuration
• D. It does not support high availability of management functions when operating in cluster mode

Answer: A

NEW QUESTION 22
Refer to the exhibit.

A network engineer must block access for all computers on VLAN 20 to the web server via HTTP All other computers must be able to access the web server Which configuration when applied to switch A accomplishes this task?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: B

NEW QUESTION 23
An engineer is asked to protect unused ports that are configured in the default VLAN on a switch. Which two steps will fulfill the request? (Choose two)

• A. Configure the ports in an EtherChannel.
• B. Administratively shut down the ports
• C. Configure the port type as access and place in VLAN 99
• D. Configure the ports as trunk ports
• E. Enable the Cisco Discovery Protocol

Answer: AD

NEW QUESTION 24
Which mode allows access points to be managed by Cisco Wireless LAN Controllers?

• A. autonomous
• B. lightweight
• C. bridge
• D. mobility express

Answer: B

NEW QUESTION 25
......