Q1. When using the CLI command eping, configured for auto-anchor mobility wireless guest access, which type of packet is tested?
A. data packets
B. mobility unencrypted packets
C. mobility encrypted packets
D. SNMP control packets
E. NTP control packets
Answer: A
Q2. What two methods of authentication are available for Local EAP?
A. LDAP and RADIUS
B. Local and RADIUS
C. Local Only
D. LDAP and Local
Answer: D
Q3. RAG DROP
Answer:
Q4. Refer to the exhibit. A customer is determining whether a Windows 7 laptop is operating on the correct IEEE 802.11 standard. Which standard is being used by the laptop in the exhibit?
A. 802.11b
B. 802.11g
C. 802.11n
D. 802.11p
Answer: C
Q5. Refer to the exhibit.
A wireless network that consists of Cisco Aironet 1260 APs and Cisco 2100 Series WLC has been correctly configured with Cisco WCS version 7, which is also used for management. The CleanAir Zone of Impact is not visible for the respective Cisco WCS maps.
Which two issues are causing the problem? (Choose two.)
A. software version
B. AP
C. Cisco WLC
D. Cisco MSE
E. Cisco WCS
F. Cisco WCS is not enabled.
Answer: B,D
Q6. Which path do you take to manage the results of a report that had been run on network utilization?
A. Reports > Report Launch Pad > Device > Utilization
B. Reports > Report Launch Pad > Scheduled Run Results
C. Reports > Saved Reports > Scheduled Run Results
D. Reports > Scheduled Run Results
Answer: D
Q7. Which two statements about AES-CCMP are true? (Choose two.)
A. It is an encryption algorithm used in the 802.11i security protocol.
B. It is defined in 802.1X.
C. It is the encryption algorithm used in TKIP implementations.
D. It is required in WPA.
E. It is required in WPA2.
Answer: A,E
Q8. Refer to the exhibit.
Which menu gives you access to manage background tasks in Cisco WCS?
A. None, because the General tab provides access to the management of background tasks
B. Monitor
C. Configure
D. Services
E. Administration
F. Tools
Answer: E
Q9. An engineer assists a user in configuring an Android device for authentication to an IEEE 802.1x EAP WLAN with PEAPv1. The Phase 2 authentication should be configured as which option?
A. LEAP
B. MSCHAPv2
C. TLS
D. TTLS
Answer: B
Q10. Tablets and other wireless clients are unable to connect at any 802.11 n data rates. What is the most likely cause of this problem?
A. WLAN > General properties are incorrectly configured.
B. WLAN > QoS properties are incorrectly configured.
C. WLAN > Security properties are incorrectly configured.
D. WLAN > Advanced properties are incorrectly configured.
E. Wireless > AP > 802.11 a/n is incorrectly configured.
F. Wireless > 802.11a/n > Network is incorrectly configured.
Answer: C