200-355 Exam - WIFUND Implementing Cisco Wireless Network Fundamentals

Question No: 2

Which four levels of messages will be sent to the logging server? (Choose four.)

A. alerts

B. critcal

C. debugging

D. emergencies

E. errors

F. informational

G. notifications

H. warnings

View Answer

Question No: 3

How many RADIUS servers can be configured globally and per WLAN on a Cisco WLC version 7.0?

A. 7 global; additional 1 per WLAN

B. 7 global; additional 3 per WLAN

C. 17 global; additional 1 per WLAN

D. 17 global; additional 3 per WLAN

E. 7 global; reuse of up to 1 maximum per WLAN

F. 17 global; reuse of up to 1 maximum per WLAN

G. 17 global; reuse of up to 3 maximum per WLAN

View Answer

Question No: 4

When using multiple SSIDs on a lightweight AP, how does the traffic of each SSID reach the 802.3 network?

A. provide routing between them at the core so that the SSIDs can reach the internet

B. configure 802.11q trunking on the Ethernet switch port that is connected to the AP

C. configure ACLs at the switch port that will allow all desired SSIDs to pass traffic

D. configure the SSIDs on the WLC and it will regulate the traffic based on traffic type

View Answer

Question No: 5

An engineer wants to set up guest wireless that requires users to log in via a splash page prior to accessing the network. Which authentication method should be configured?

A. LDAP

B. RADIUS

C. local authentication

D. WebAuth

E. PSK

View Answer

Question No: 6

A client is attached to the Cisco Unified Wireless Network using controllers.

When the client is using WPA2 and EAP authentication, where are the wireless encryption keys located during the active user session? (Choose two.)

A. On the access point

B. On the RADIUS server

C. On the Cisco WCS

D. On the client

E. On the Cisco WLC

View Answer

Question No: 7

What does RF determine?

A. cycle pattern size

B. how often a wave occurs

C. signal size

D. quantity of energy injected in a signal

View Answer

Question No: 8

Which three items do you need to establish a wireless connection to an enterprise wireless network? (Choose three.)

A. SSID name

B. RF channel

C. RF signal

D. 802.1X/EAP credentials

E. pre-shared key

F. web page

G. WPA/WPA2 settings

View Answer

Question No: 9

The network administrator receives complaints of slow wireless network performance and performs a sniffer trace of the wireless network in preparation for migration to 802.11n. The sample capture shows frames that contains AP beacons with NonERP_Present bit set to 1 and frames with RTS/CTS.

Which two conclusions can be interpreted from these frames? (Choose two.)

A. The network is performing slowly because 802.11n clients are already mixed with 802.11g clients.

B. The network is performing slowly because 802.11b clients still exist in the network.

C. The network is performing slowly because a wireless client is incorrectly configured, which results in RF interference.

D. Possible 802.11b wireless clients are located only in the AP cell radius where the sniffer capture was performed.

E. Possible 802.11b wireless clients could be located anywhere in the wireless network.

View Answer

Question No: 10

Refer to the exhibit. Which two wireless functions is the client experiencing? (Choose two.)

A. Inter-controller Roaming

B. Intra-controller Roaming

C. Layer 2 Roaming

D. Layer 3 Roaming

E. Inter-subnet roaming

F. Re-authentication

View Answer

Question No: 11

Which three items are allowed on an Ethernet trunk port? (Choose three.)

A. autonomous AP

B. FlexConnect AP

C. local AP

D. monitor AP

E. rogue detector AP

F. sniffer AP

G. SE-Connect AP

H. Cisco WLC

View Answer