200-355 Exam - WIFUND Implementing Cisco Wireless Network Fundamentals

Question No: 12

Strong security is required, but a centralized RADIUS authenticator has not been implemented.

Which two steps must you take to provide maximum security when using a pre-shared key? (Choose two.)

A. Change the TKIP on a weekly basis.

B. Use a key that includes mixed-case letters, numbers, and symbols with a length greater than 10 characters.

C. Use only with WPA and WPA2, following proper strong key guidelines.

D. Use the longest possible WEP key in your security policy.

View Answer

Question No: 13

Which two Cisco Unified Wireless Network capabilities use information that is provided by Radio Resource Management neighbor messages in version 7.0 MR1? (Choose two.)

A. aggressive load balancing

B. dynamic channel assignment

C. hybrid remote edge access point

D. inter-controller mobility (that is, mobility groups)

E. rogue AP classification

View Answer

Question No: 14

A customer has asked for the proper port configuration to allow for LAG on a Cisco 2504 Wireless Controller to a Cisco IOS switch. Which EtherChannel mode should be used on the switch to allow for the WLC to connect?

A. on

B. auto

C. desirable

D. passive

E. active

View Answer

Question No: 15

Which interface is considered a dynamic interface?

A. the virtual interface

B. the AP manager interface

C. the LAG interface

D. the management interface

E. the service port interface

F. a WLAN client data interface

View Answer

Question No: 16

Which RRM feature allows an access point to avoid non-IEEE 802.11 interference?

A. DCA

B. TPC

C. RF groups

D. coverage hole detection

View Answer

Question No: 17

You are designing a wireless network in a medical facility. Which three areas are bad locations in which to install a wireless access point? (Choose three.)

A. in front of the elevators doors

B. in the hallways

C. next to the electrical room

D. inside offices

E. near medical imaging devices

F. in the lobby

View Answer

Question No: 18

Which of the following are three functions of Cisco RRM? (Choose three.)

A. TPC

B. intercontroller roaming

C. dynamic channel assignment

D. intracontroller roaming

E. coverage hole detection

View Answer

Question No: 19

Which EAP protocol requires a certificate only on the server side?

A. EAP-PEAP

B. EAP-FAST

C. EAP-TLS

D. EAP-SSL

View Answer

Question No: 20

A customer has a corporate SSID that is configured to authenticate against an ACS server to validate client credentials on the corporate SSID. The customer has a firewall logically positioned on the network between the WLC and the ACS server in the network architecture. Which port must the firewall allow to ensure that authentication can occur?

A. 43

B. 1812

C. 5146

D. 8143

View Answer

Question No: 21

Refer to the exhibit. A network administrator is attempting to connect to the GUI of a WLC with interfaces as shown. Which IP address should the network administrator use?

A. 192.168.0.2

B. 192.168.1.2

C. 192.168.2.2

D. 192.168.3.2

E. 192.168.4.2

View Answer