200-355 Exam - WIFUND Implementing Cisco Wireless Network Fundamentals

Question No: 8

An autonomous AP maps the SSID to what on the wired network?

A. BSSID

B. VLAN

C. QoS tag

D. SG tag

View Answer

Question No: 9

Which two of the following authentication methods used for WiFi security require the use of certificates? (Choose two.)

A. PEAP

B. EAP-FAST

C. WPA2

D. WPA1

E. EAP-TLS

F. EAP-MD5

View Answer

Question No: 10

An enterprise needs their iPhones to connect to the EAP-TLS network. How should the devices be configured?

A. push profile and certificate through Configuration Utility

B. configure directly through Settings application

C. email certificate to device then configure through Settings application

D. download certificate from web page then configure through Settings application

E. push profile and certificate through iTunes

View Answer

Question No: 11

Which two options are limitations when configuring basic security on an autonomous AP using the express security page setup? (Choose two.)

A. Delete all the SSIDs.

B. Edit the SSIDs.

C. You cannot change the default SSID.

D. You need multiple SSIDs.

E. Use multiple authentication servers.

View Answer

Question No: 12

A customer is reviewing Cisco Prime Infrastructure to identify malicious rogue access points that are operating within the customer environment. Which dashboard in Cisco Prime Infrastructure displays this information by default?

A. Context Aware

B. CleanAir

C. Security

D. General

View Answer

Question No: 13

When configuring a WLC to support multiple WLANs, which type of interface must be created?

A. dynamic

B. ap-manager

C. virtual

D. management

View Answer

Question No: 14

Refer to the exhibit.

A wireless network that consists of Cisco Aironet 1260 APs and Cisco 2100 Series WLC has been correctly configured with Cisco WCS version 7, which is also used for management. The CleanAir Zone of Impact is not visible for the respective Cisco WCS maps.

Which two issues are causing the problem? (Choose two.)

A. software version

B. AP

C. Cisco WLC

D. Cisco MSE

E. Cisco WCS

F. Cisco WCS is not enabled.

View Answer

Question No: 15

An engineer has just deployed a Cisco Aironet 3702 Access Point with an access layer switch that supports IEEE 802.1af Power over Ethernet. How will the access points react to the wattage that is available in 802.1af?

A. disable the BVI interface

B. fail to boot in CAPWAP mode

C. operate in 3x3 MIMO mode

D. enable the 2.4-GHz radios with 40-MHz channel bonding

View Answer

Question No: 16

An engineer is connecting a Cisco 5508 Wireless Controller that must connect to an out-of- band management network for management only. Which two options should be used for the port on the WLC and the cable type? (Choose two.)

A. service port

B. redundancy port

C. console port

D. distribution system port

E. straight through cable

F. crossover cable

G. console cable

View Answer

Question No: 17

What is the purpose of the Log Analysis tab on the Client Troubleshooting page in Cisco WCS?

A. After you click start, the tab shows debug information for the client that is trying to re- associate.

B. The tab searches the logs for similar problems of other clients and generates a report.

C. The tab generates a report from historical logs for the client that is having problems.

D. The tab shows logs from the past hour for the client that is having problems.

View Answer