200-355 Exam - WIFUND Implementing Cisco Wireless Network Fundamentals

Question No: 1

An engineer recently removed a WLC from a WCS, but the APs associated to the WLC are still showing on the WCS. What is a reason for this?

A. The associated APs must be removed manually.

B. The APs must be removed from the WCS map.

C. The hold-down timer must expire before the APs will be removed.

D. The APs must be audited.

View Answer

Question No: 2

A customer is deploying the Cisco 5508 Wireless Controller in a unified wireless solution. Which command must be configured on the neighboring switch port if the management interface on the WLC is configured to send untagged traffic to ensure that management traffic utilizes VLAN 10?

A. switchport trunk native vlan 10

B. spanning-tree portfast

C. switchport trunk allowed vlan 10

D. channel-group 10

View Answer

Question No: 3

An engineer is using WCS' client troubleshooting tool to investigate issues with a client device. What is the longest log capture they will be able to take?

A. 2 minutes

B. 5 minutes

C. 10 minutes

D. 30 minutes

View Answer

Question No: 4

Refer to the exhibit.

Which option is the received signal power level at the receiver?

A. -46

B. -49.28

C. -45

D. -40.72

View Answer

Question No: 5

Which three access point modes service clients? (Choose three.)

A. FlexConnect

B. bridge

C. sniffer

D. local

E. monitor

F. SE-Connect

View Answer

Question No: 6

Which module does the Cisco AnyConnect Secure Mobility client integrate into the AnyConnect client package for access to both wired and wireless networks?

A. Network Access Manager

B. Telemetry

C. Web Security

D. DART

View Answer

Question No: 7

An AP using version 7.0 MR1 broadcasts a Layer 3 CAPWAP discovery message on the local IP subnet. Which step does the AP take next?

A. Determine if the controller responses include the primary controller.

B. Determine if the controller responses include the master controller.

C. Send a discovery request using DHCP option 43.

D. Send a discovery request using DNS.

E. Send a discovery request using locally stored information on the AP.

F. Send a discovery request using OTAP.

View Answer

Question No: 8

Which Cisco WCS tool allows you to view current reports, open specific types of reports, create and save new reports, and manage scheduled runs?

A. Reports menu

B. Reports launch page

C. Scheduled Run results

D. saved reports

View Answer

Question No: 9

Following a WLC upgrade you want to check what version of code the access point is running. Where can you find this information?

A. CLI > show sysinfo

B. GUI > Monitor > Software Version

C. CLI > show running configuration

D. GUI > Wireless > Access point > General

View Answer

Question No: 10

What three components must be the same on a controller and the RADIUS server when adding a RADIUS server to a WLC? (Choose three.)

A. Username

B. Shared Secret

C. Index Priority

D. Port Number

E. IP Address

F. Network Mask

View Answer