201 Exam - TMOS Administration

NEW QUESTION 1
A BIG-IP Administrator contacts F5 Support, which identifies a suspected hardware failure. Which information should the BIG-IP Administrator provide to F5 Support?

• A. Qkview, EUD output
• B. Qkview, UCS archive, core files
• C. Qkview, part numbers for failed components
• D. Qkview, packet capture, UCS archive

Answer: A

NEW QUESTION 2
Refer to the exhibit.
Which TMSH command generated this output?

• A. tmsh list /cm sync-status
• B. tmsh show /sys sync-status
• C. tmsh list /sys sync-status
• D. tmsh show /cm sync status

Answer: D

NEW QUESTION 3
One of the two members of a device group has been decommissioned. The BIG-IP Administrator tries to delete the device group, but is unsuccessful.
Prior to removing the device group, which action should be performed?

• A. Disable the device group
• B. Remove all members from the device group
• C. Remove the decommissioned device from the device group
• D. Make sure all members of the device group are in sync

Answer: B

NEW QUESTION 4
A BIG-IP Administrator is informed that traffic on Interface 1.1 is expected to increase over the maximum bandwidth capacity on the link. There is a single VLAN on the Interface. What should the 8IG-IP Administrator do to increase the total available bandwidth?

• A. Assign two Interfaces to the VLAN
• B. Set the media speed of Interface 1.1 manually
• C. Create a trunk object with two Interfaces
• D. Increase the MTU on the VLAN using Interface 1.1

Answer: C

NEW QUESTION 5
A BIG-IP device has only LTM and ASM modules provisioned. Both have nominal provisioning level. The BI6-IP Administrator wants to dedicate more resources to the LTM module. The ASM module must remain enabled. Which tmsh command should the BIG-IP Administrator execute to obtain the desired result?

• A. modify/sys provision asm level minimum
• B. modify /sys provision Itm level dedicated
• C. modify /sys provision asm level none
• D. modify /sys provision Itm level minimum

Answer: A

NEW QUESTION 6
A site has assigned the ICMP monitor to all nodes and a custom monitor, based on the HTTP template, to a pool of web servers. The HTTP based monitor is working in all cases. The ICMP monitor is failing for 2 of the pool member 5 nodes. All other settings are default. What is the status of the monitor is working in all cases?

• A. All pool members are up since the HTTPbased monitor is successful.
• B. All pool members are down since the ICMPbased monitor is failing in some cases.
• C. The pool members whose nodes are failing the ICMPbased monitor will be marked disabled.
• D. The pool members whose nodes are failing the ICMPbased monitor will be marked unavailable.

Answer: D

NEW QUESTION 7
When upgrading a BIG-IP redundant pair, what happens when one system has been updated but the other has not?

• A. Synching should not be performed.
• B. The first system to be updated will assume the Active role.
• C. This is not possible since both systems are updated simultaneously.
• D. The older system will issue SNMP traps indicating a communication error with the partner.

Answer: A

NEW QUESTION 8
A BIG-IP Administrator plans to resolve a non-critical issue with a BIG-IP device in 2 weeks. What Severity level should be assigned to this type of F5 support ticket?

• A. 4
• B. 2
• C. 3
• D. 1

Answer: A

NEW QUESTION 9
A BIG-IP Administrator needs to modify a virtual server that web offload web traffic compression tasks from the target server.
Which two profiles must the BIG-IP Administrator apply to a virtual server to enable compression? (Choose two)

• A. Server SSL profile
• B. Stream profile
• C. Persistence profile
• D. HITP profile
• E. Compression profile

Answer: DE

NEW QUESTION 10
A BIGJP Administrator needs to load a UCS file but must exclude the license file. How should the administrator perform this task?

• A. From the CLI with command U tmsh load /$ys ucs <ucs filename> no-license
• B. From the GUI, select the UCS file, unchcck the license box, and click restore
• C. From the CLI with command(tmos)« tmsh load /sys ucs <ucs filename> no-license
• D. From the GUI, select the UCS file and click restore

Answer: A

NEW QUESTION 11
A BIG-IP Administrator is setting up a new BIG-IP device. The network administrator reports that the interface has an incompatible media speed. The BIG-IP Administrator needs to change this setting
manually.
From which location should the BIG-IP Administrator perform this task?

• A. On the Front Console
• B. In the TMOS Shell Command line
• C. In the Configuration Utility, Network > Interface
• D. In the Configuration Utility, System > Configuration

Answer: C

NEW QUESTION 12
A BIG-IP Administrator needs to check the memory utilization on a BIG-IP system. Which two methods can the UIG IP Administrator use? (Choose two.)

• A. Run the tmsh show/sys memory command
• B. Run the tmsh show/sys traffic command
• C. Go to Statistics > Module Statistics > Traffic Summary in the configuration utility
• D. Go to Statistics > Module Statistics > Memory in the configuration utility
• E. Go to System > Disk Management in the configuration utility

Answer: AD

NEW QUESTION 13
A BIG-IP Administrator needs to remove a pool specific health monitor. There is a pool named Best Pool with two members, one named Best pool member and one named Best pool member2. In the Local Traffic section of the administrative GUI, which stops should the BIG-IP Administrator take to remove a pool level monitor?

• A. Pool > Pool List > Best Pool > Members > Health Monitors
• B. Nodes > Node List> Best _pool_memberl > Heath Monitors
• C. Monitors > Monitor Name> Instances
• D. Pool > Pool List> Best Pool > Health Monitors

Answer: D

NEW QUESTION 14
Which two statements are true about NATs? (Choose two.)

• A. NATs support UDP, TCP, and ICMP traffic.
• B. NATs can be configured with mirroring enabled or disabled.
• C. NATs provide a one-to-one mapping between IP addresses.
• D. NATs provide a many-to-one mapping between IP addresses.

Answer: AC

NEW QUESTION 15
Which log file should the BIG-IP Administrator check to determine if a specific user tried to log in to the 8IG-IP Configuration by utility?

• A. /var/log/pam/tally/log
• B. /ver/log/secure
• C. /var/log/trn
• D. /var/log/http.d

Answer: B

NEW QUESTION 16
Which statement accurately describes the difference between two loadbalancing modes specified as "member" and "node"?

• A. There is no difference; the two terms are referenced for backward compatibility purposes.
• B. When the loadbalancing choice references "node", priority group activation is unavailable.
• C. Loadbalancing options referencing "nodes" are available only when the pool members are defined for the "any" port.
• D. When the loadbalancing choice references "node", the addresses' parameters are used to make the loadbalancing choice rather than the member's parameters.

Answer: B

NEW QUESTION 17
......