Q1. If no SIP dial rules are configured on an IP phone, at which three points in the collection of digits does a Type A SIP phone send digits to the Cisco Unified Communications
Manager? (Choose three.)
A. when the interdigit timer expires
B. when the collected digits match a SIP dial rule
C. when the user presses the Dial softkey
D. as each digit is collected (it is sent for analysis)
E. when the user presses the # key
Answer: A,C,E
Q2. The Ajax Corporation is designing an IP telephony network using Cisco MCS 7845 Series
servers, eachone capable of supporting 7500 devices. The design must meet these requirements:
-Be cost-effective
-Support up to 7500 phones
-Provide a minimal level of redundancy
A. Two Cisco Unified Communications Manager servers:
1 publisher and TFTP server combined.
1 primary subscriber.
B. Three Cisco Unified Communications Manager servers:
1 publisher and TFTP server combined.
1 primary subscriber.
1 backup subscriber.
C. Four Cisco Unified Communications Manager servers:
1 publisher.
1 TFTP server.
1 primary subscriber.
1 backup subscriber.
D. Five Cisco Unified Communications Manager servers:
1 publisher.
1 TFTP server.
1 primary subscriber.
2 backup subscribers.
Answer: B
Q3. The Cisco TelePresence Conductor will not handle conference requests if the administrator username/ password is configured as which of these options?
A. admin/TANDBERG
B. administrator/TANDBERG
C. tandberg/Cisco
D. admin/Cisco
E. cisco/Cisco
F. administrator/Cisco
G. cisco/TANDBERG
Answer: A
Explanation:
Reference: http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/conductor/config_gui de/ TelePresence-Conductor-Unified-CM-Deployment-Guide-XC2-3.pdf
Q4. Which of these media resources can be configured in Cisco Unified Communication manager?
(Choose Three)
A. MOH Server
B. Voice Termination Point DSP
C. Transcoder
D. Auto Attendant
E. Conference Bridge
Answer: A,C,E
Q5. A customer recently installed a Cisco TelePresence MCU 5320. The customer wants a
virtual meetingroom that restricts participants from communicating before the customer joins the call.
Which featurein the MCU enables this functionality?
A. Floor and chair control.
B. Numeric ID.
C. PIN codes.
D. Owner.
Answer: A
Explanation: Reference:
http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/mcu/admin_guide/cis co_telepresence_mcu_5300_series_administration_guide_4-3_2-17.pdf
Q6. When local route groups are used and a user dials 918005551212, what component is ultimately used to route the digits to the local gateway?
A. The route list applied to the route pattern
B. The device pool of the calling device
C. The translation pattern
D. The gateway or route list associated with the +.! route pattern
Answer: B
Q7. Refer to the exhibit.
A Network Administrator needs to create a SIP route pattern to communicate with Monterrey's Gateway.
The Administrator does not understand why this is not working properly. Which two statementsexplain the issue and resolve the problem?(Choose two.)
A. The issue is caused by a failure of communication between the Monterrey's Gateway and CUCM.
B. The Administrator should type the reload command into Monterrey's Gateway.
C. The issue is caused by incorrect protocol integration between Monterrey's Gateway and CUCM.
D. The Administrator needs to set up a SIP trunk between Monterrey's Gateway and CUCM.
Answer: C,D
Q8. Which two of the following DSPs can be used inheterogeneousconferencing to achieve the required trans-sizing and transcoding functionality? (Choose two.)
A. PVDM3-256
B. PVDM2-256
C. PVDM-192
D. PVDM3-32
E. PVDM3-192
F. PVDM2-128
Answer: A,E
Explanation:
Reference:
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/feature/guide/Video-trans-conf.html#wp1054669