Q1. Refer to the exhibit and configuration output.
A user in New York (5001) is trying to call a user in London (6001), but the call cannot be completed. Assuming that the WAN uplink is failing and the voice traffic has to go out toward the PSTN, which command do you need to add to dial peer to solve this issue?
dial-peer voice 3 pots
destination-pattern 6…
preference 1
port 0/0/0:23
dtmf-relay sip-notify
A. num-exp 512602 6001
B. prefix 757385
C. forward-digits 2
D. forward-digits 4
E. prefix 5126
Answer: B
Q2. What are two characteristics of a partition? (Choose two.)
A. Assigned to sources of call routing requests
B. Any group of numbers with the same reachability
C. Used in conjunction with calling search spaces to track calls to certain numbers
D. Used in conjunction with calling search spaces to restrict outgoing calls to certain numbers
E. Contains calling search spaces
Answer: B,D
Q3. Refer to the exhibit.
What is the command to place the static IP address by CLI in the CiscoTelePresence MSE 8000?
A. MSE 8050: static 0 10.10.2.13 255.255.255.255 10.10.2.1 200.87.100.10 200.87.100.20.
B. MSE 8050: static 0 10.10.2.13 255.255.255.0 10.10.2.1 200.87.100.10 200.87.100.20.
C. MSE 8050: static 1 10.10.2.13 255.255.255.0 10.10.2.1 200.87.100.10 200.87.100.20.
D. MSE 8050: static ip 0 10.10.2.13 255.255.255.0 10.10.2.1 200.87.100.10 200.87.100.20.
Answer: B
Q4. After you configure a dial plan to call a particular prefix in the PSTN, you notice that some outbound calls are taking longer than usual (15 seconds) before you hear a connecting tone. What is the likely cause of this issue?
A. The outbound gateway must be configured with the new prefix.
B. The endpoint is choosing the best codec to use.
C. The new prefix is overlapping other route patterns.
D. With some prefixes, this is normal behavior of the PSTN.
Answer: C
Explanation: Reference:
Page 107
CIPTV110SG_Vol1
Q5. Which two options are IOS conference bridge types in CUCM? (Choose two)
A. CiscoIOS Enhanced Conference Bridge
B. CiscoIOS Standard Conference Bridge
C. CiscoIOS Software Conference Bridge
D. CiscoIOS Hardware Conference Bridge
E. Cisco IOS Conference Bridge
Answer: A,E
Explanation: Reference:
Page 367
Cisco Unified Communications Manager Administration Guide, Release 10.0(1)
Q6. On what equipment do you configure Layer 2 to Layer 3 QoS mapping?
A. switch
B. router
C. firewall
D. Cisco Unified Communications Manager
E. bridge
Answer: B
Q7. Which protocol is recommended to be used between Cisco Unified Communications Manager and thevoice gateway to simplify the dial plan?
A. SIP.
B. SCCP.
C. H323.
D. RSVP.
E. MGCP.
Answer: E
Q8. How do you configure calling privileges on Cisco Unified Communications Manager Express?
A. corlist
B. translation profile
C. zones
D. access list
E. search rules
Answer: A
Q9. Which command is used to enter the DSP farm profile configuration mode?
A. dspfarm-profile 100 transcode
B. dspfarmprofile 100 transcode
C. dspfarm profile 100 transcode
D. dspfarm 100 profile transcode
Answer: C
Q10. Which three steps must you take on Cisco Unified Communications Manager to configure
Cisco TelePresence Conductor for ad hoc and rendezvous conferences? (Choose three.)
A. Verify the location configuration.
B. Verify the certificate trusts.
C. Configure one ICT trunk to TelePresence Conductor.
D. Configure one SIP trunk to TelePresence Conductor.
E. Configure two ICT trunks to TelePresence Conductor.
F. Configure two SIP trunks to TelePresence Conductor.
Answer: A,B,F