Q1. When an external call is placed from Ajax, they would like the ANI that is sent to the PSTN to be the main number, not the extension. For domestic calls, they would like 10 digits sent; for international calls, they would like to send the country code 1 and the 10 digits. How can this be accomplished?
A. Add a translation pattern to the dial peers in the gateway that adds the appropriate digits to the outgoing ANI.
B. In the external call route patterns, set the external phone number mask to the main number. Use 10 digits in the domestic route pattern and 1 followed by the main number digits in the international route patterns.
C. Use a calling party transform mask for each route group in the corresponding route list configuration. Set the explicit 10-digit main number for domestic calls and 1 followed by the main number for the international route patterns.
D. In the directory number configurations, set the prefix digits field to the country code and the 10 digits of the main number. This will be truncated to the 10-digit number for domestic calls and sent out in its entirety for international calls.
Answer: C
Explanation:
Incorrect Answer: A, B, D calling party transformation mask value is Valid entries for the NANP include the digits 0 through 9; the wildcard characters X, asterisk (*), and octothorpe (#); and the international escape character +. Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucmbe/admin/8_6_1/ccmcfg/b03trpat.ht ml
Q2. You are deploying a remote office setup that connects with Cisco Unity Communications Manager at a hub location. You have an available dedicated bandwidth of 20% from the 2-Mb/s WAN circuit for VoIP that supports a maximum of 17 calls. Which codec do you configure in Cisco Unity Communications Manager to achieve this?
A. G.722
B. G.711
C. G.729
D. iSAC
E. GSM-FR
F. iLBC
Answer: C
Q3. Refer to the exhibit.
The exhibit shows centralized Cisco Unified Communications Manager configuration components for TEHO calls to U.S. area code 408 from the U.K. The PSTN access code for the U.K. is 9 and 001 for international calls to the U.S. Assuming the PSTN does not accept globalized numbers with + prefix. What should the Called Party Transformation Pattern at the U.S. gateway be configured as?
A. \+.! with the following Called Party Transformation:Discard Digits PreDot Prefix Digits Outgoing Calls: +
B. \+1.! with the following Called Party Transformation:Discard Digits PreDot Prefix Digits Outgoing Calls: None
C. \+408.! with the following Called Party Transformation:Discard Digits PreDot Prefix Digits Outgoing Calls: 1
D. \+1408.! with the following Called Party Transformation:Discard Digits PreDot Prefix Digits Outgoing Calls: None
E. \+1.408! with the following Called Party Transformation:Discard Digits PreDot Prefix Digits Outgoing Calls: None
Answer: D
Q4. Company X has deployed a VCS Control with a local zone and a traversal client zone. To facilitate external calls, VCS Expressway is deployed and traversal server zone is set up there. Video endpoints inside Company X have registered but are unable to receive calls from outside endpoints. Which option could be the cause of this issue?
A. The access control list on the VCS Control must be updated with the IP for the external users.
B. When a traversal zone is set up on VCS Control only outbound calls are possible.
C. The local zone on the VCS Control does not have a search rule configured.
D. The traversal zone on the VCS Control does not have a search rule configured.
Answer: C
Q5. You have been asked to deploy Cisco Extension Mobility Cross Cluster for a distributed call processing environment. During the initial extension mobility login request, how does the visiting cluster determine if the user is a local user or a remote user?
A. by using a third-party automatic provisioning tool to verify user ID
B. by broadcasting a request to all clusters to verify the user type
C. from user IDs that are created by default when the user logs in
D. by using Extension Mobility Cross Cluster Session Initiation Protocol (SIP) trunks
E. by verifying against the local database
F. by verifying the visiting Trivial File Transfer Protocol
Answer: E
Q6. What happens if location-based CAC is used and there is no bandwidth available when a remote caller is placed on hold?
A. Cisco Unified Communications Manager sends TOH rather than MOH.
B. Cisco Unified Communications Manager terminates the call.
C. Cisco Unified Communications Manager plays default MOH.
D. Cisco Unified Communications Manager attempts to reconnect the call immediately.
Answer: A
Q7. Refer to the exhibit:
The exhibit shows a SAF Forwarder configuration attached to a Cisco Unified Communications Manager.
Which minimum configuration for a Cisco Unified Communications Manager Express SAF Forwarder is needed to establish a SAF neighbor relationship with this SAF Forwarder?
A. router eigrp SAFiservice-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-familyvoice service safprofile trunkroute 1session protocol sip interface Loopback1 transport tcp port 5060!
B. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit- service-family!voice service safprofile trunk-route 1session protocol sip interface Loopback1 transport tcp port 5060!profile dn-block 1 alias-prefix 1972555pattern 1 type extension 4xxx!profile callcontrol 1dn-servicetrunk-route 1dn-block 1dn-block 2!channel 1 vrouter SAF asystem 1subscribe callcontrol wildcardedpublish callcontrol 1!
C. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family!
D. None of above configurations contain sufficient information.
Answer: C
Explanation:
Incorrect Answer: A, B, D only following configuration is enough router eigrp SAF service-family ipv4 autonomous-system 1 exit-service-family link:
http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6554/ps6599/ps10822/whitepaper_c11-636604.html
Q8. Which statement about technology implementation strategy is true?
A. Cisco Unified Communications Manager Express can be configured to function with no Cisco Unified Communications Manager cluster in the enterprise.
B. Cisco Unified Communications Manager Express in SRST mode can be configured to function with no Cisco Unified Communications Manager cluster in the enterprise.
C. SRST can be configured to function with no Cisco Unified Communications Manager cluster in the enterprise.
D. SRST and MGCP fallback can be configured to function with no Cisco Unified Communications Manager cluster in the enterprise.
Answer: A
Q9. Which statement about H.323 Gatekeeper Call Admission Control is true?
A. Gatekeeper Call Admission Control applies to centralized Cisco Unified Communications deployments that use locations based Call Admission Control.
B. Gatekeeper Call Admission Control applies to distributed Cisco Unified Communications deployments.
C. Gatekeeper Call Admission Control applies only to distributed Cisco Unified Communications Express deployments.
D. Gatekeeper Call Admission Control setting is configured in Cisco Unified Communications Manager.
Answer: B
Explanation:
Incorrect Answer: A, C, D in distributed call processing deployments on a simple hub-and-spoke topology, you can implement call admission control with a Cisco IOS gatekeeper. In this design, the call processing agent (which could be a Unified CM cluster, Cisco Unified Communications Manager Express (Unified CME), or an H.323 gateway) registers with the Cisco IOS gatekeeper and queries it each time the agent wants to place an IP WAN call. Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/cac.html#wp1044743
Q10. Which symbol is required for globalized call routing?
A. +
B. *
C. %
D. /
E. ;
Answer: A