300-101 Exam - ROUTE Implementing Cisco IP Routing

certleader.com

P.S. Printable 300-101 forum are available on Google Drive, GET MORE: https://drive.google.com/open?id=1IPFRgHPm2o-6qCPBhQuk3ypuFkiGdV3b


New Cisco 300-101 Exam Dumps Collection (Question 9 - Question 18)

New Questions 9

A network engineer enables a trunk port and encounters the following message:%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet 1/1, changed state to up. What is the severity level of this message?

A. alert

B. critical

C. notification

D. informational

Answer: C


New Questions 10

Which NetFlow component is applied to an interface and collects information about flows?

A. flow monitor

B. flow exporter

C. flow sampler

D. flow collector

Answer: A


New Questions 11

Using the rules for IPv6 addressing, how can the address 2031:0000:240F:0000:0000:09C0:123A:121B be rewritten?

A. 2031:0:240F::09C0:123A:121B

B. 2031::240F::09C0:123A:121B

C. 2031::240F:9C0::123A:121B

D. 2031::240F:::09C0:123A:121B

Answer: A

Explanation:

Leading zeros can be truncated. For example u201c0000 can be be just written as empty. In the above example :: indicates that it has multiple 0s in that location. Typically the IPv6 format can be written down in three ways 1) compressed, 2) uncompressed and 3) fully uncompressed as shown below. All of the following are the same:


New Questions 12

Refer to the exhibit. On the basis of the output from the show ipv6 interface command, what two statements must be true? (Choose two.)

A. Interface Ethernet 0/0 was configured with the ipv6 ospf 1 area 1 command.

B. Interface Ethernet 0/0 has been configured with the ipv6 ospf authentication ipsec spi 500 md5 command.

C. OSPF version 3 is enabled to support IPv6.

D. The IP address of the designated router (DR) is FE80::A8BB:CCFF:FE00:6E00.

E. This is the designated router (DR) on the Ethernet 0/0 link.

Answer: B,C


New Questions 13

Various employees in the same department report to the network engineer about slowness in the network connectivity to the Internet. They are also having latency issues communicating to the network drives of various departments. Upon monitoring, the engineer finds traffic flood in the network. Which option is the problem?

A. network outage

B. network switching loop

C. router configuration issue

D. wrong proxy configured

Answer: B


New Questions 14

Which CLI command can you enter to permit or deny IPv6 traffic travelling through an interface?

A. access-list

B. access-group

C. ipv6 access-class

D. ipv6 traffic-filter

Answer: D


New Questions 15

A network engineer is considering enabling load balancing with EIGRP. Which consideration should be analyzed?

A. EIGRP allows a maximum of four paths across for load balancing traffic.

B. By default, EIGRP uses a default variance of 2 for load balancing.

C. EIGRP unequal path load balancing can result in routing loops.

D. By default, EIGRP performs equal cost load balancing at least across four equal cost paths.

Answer: D


New Questions 16

Which two statements about 6to4 tunneling are accurate? (Choose two.)

A. Prepending a reserved IPv6 code to the hexadecimal representation of 192.168.0.1 facilitates 6to4 tunneling.

B. Each 6to4 site receives a /48 prefix in a 6to4 tunnel.

C. 2002::/48 is the address range specifically assigned to 6to4.

D. Prepending 0x2002 with the IPv4 address creates an IPv6 address that is used in 6to4 tunneling.

E. 6to4 is a manual tunnel method.

Answer: B,D


New Questions 17

An engineer is configuring a GRE tunnel interface in the default mode. The engineer has assigned an IPv4 address on the tunnel and sourced the tunnel from an Ethernet interface. Which option also is required on the tunnel interface before it is operational?

A. tunnel destination address

B. keepalives

C. IPv6 address

D. tunnel protection

Answer: A


New Questions 18

What are the four main steps in configuring a GRE tunnel over IPsec on Cisco routers? (Choose Four)

A. Configure a physical interface or create a loopback interface to use as the tunnel endpoint.

B. Create the GRE tunnel interfaces.

C. Add the tunnel interfaces to the routing process so that it exchanages routing updates across that interface.

D. Add the tunnel subnet to the routing process so that it exchanages routing updates across that interface.

E. Add all subnets to the crypto access-list, so that IPsec encrypts the GRE tunnel traffic.

F. Add GRE traffic to the crypto access-list, so that IPsec encrypts the GRE tunnel traffic.

Answer: A,B,D,F


P.S. Easily pass 300-101 Exam with Thedumpscentre Printable Dumps & pdf vce, Try Free: http://www.thedumpscentre.com/300-101-dumps/ (436 New Questions)