300-101 Exam - ROUTE Implementing Cisco IP Routing

certleader.com

P.S. Refined 300-101 torrent are available on Google Drive, GET MORE: https://drive.google.com/open?id=1rlPNNoD0ZdgZsqoRN-j_tpudN825BWM5


New Cisco 300-101 Exam Dumps Collection (Question 3 - Question 12)

Question No: 3

A network administrator uses IP SLA to measure UDP performance and notices that packets on one router have a higher one-way delay compared to the opposite direction. Which UDP characteristic does this scenario describe?

A. latency

B. starvation

C. connectionless communication

D. nonsequencing unordered packets

E. jitter

Answer: A


Question No: 4

Which item does EIGRP IPv6 require before it can start running?

A. router ID

B. DHCP server

C. subnet mask

D. default gateway

Answer: A

Explanation: http://www.ciscopress.com/articles/article.asp?p=2137516&seqNum=4


Question No: 5

You have been asked to evaluate how EIGRP is functioning in a customer network.

Which key chain is being used for authentication of EIGRP adjacency between R4 and R2?

A. CISCO

B. EIGRP

C. key

D. MD5

Answer: A

Explanation: R4 and R2 configs are as shown below:

Clearly we see the actual key chain is named CISCO.


Question No: 6

Which two statements about Frame Relay LMI autosense are true on a Router? (Choose two)

A. It requires the LMI type to be explicitly configured.

B. It operates on Frame Relay DTE interfaces.

C. It operates on Frame Relay DCE interfaces.

D. It operates when the line is up by the line protocol is down.

E. It requires the line protocol to be up.

Answer: B,D

Explanation: https://www.cisco.com/c/en/us/td/docs/ios/12_2/wan/configuration/guide/fwan_c/wcffrely.ht ml


Question No: 7

Router RTA is configured as follows:

RTA (config)#router rip

RTA(config-router)#network 10.0.0.0

RTA(config-router)#distribute-list 44 in interface BRIO RTA(config-router)#exit

RTA(config)#access-list 44 deny 172.16.1.0 0.0.0.255 RTA(config)#access-list 44 permit any

What are the effects of this RIP configuration on router RTA? (Choose two)

A. no routing updates will be sent from router RTA on interface BRIO to router RTX

B. router RTA will not advertise the 10.0.0.0 network to router RTX

C. the route to network 172.16.1.0 will not be entered into the routing table on router RTA

D. user traffic from the 172.16.1.0 network is denied by access-list 44

E. the routing table on router RTA will be updated with the route to router RTW

Answer: C,E

Explanation:

Distribute list are used to filter routing updates and they are based on access lists. In this case, an access list of 44 was created to deny the route from network 172.16.1.0/24 so this route will not be entered into the routing table of RTA. But the route from RTW can be entered because it is not filtered by the access list A and B are not correct because the distribute list is applied to the inbound direction of interface BRI0 so outgoing routing updated will not be filtered.

Distribute list just filters routing updates so user traffic from network 172.16.1.0 will not be denied.


Question No: 8

PPPoE is composed of which two phases?

A. Active Authentication Phase and PPP Session Phase

B. Passive Discovery Phase and PPP Session Phase

C. Active Authorization Phase and PPP Session Phase

D. Active Discovery Phase and PPP Session Phase

Answer: D


Question No: 9

Under which condition does UDP dominance occur?

A. when TCP traffic is in the same class as UDP

B. when UDP flows are assigned a lower priority queue

C. when WRED is enabled

D. when ACLs are in place to block TCP traffic

Answer: A


Question No: 10

Refer to the exhibit.

The excerpt was taken from the routing table of router SATX. Which option ensures that routes from 51.51.51.1 are preferred over routes from 52.52.52.2?

A. SATX(config-router)#distance 90 51.51.51.1 0.0.0.0

B. SATX(config-router)#distance 89.52.52.52.2 0.0.0.0

C. SATX(config-router)#distance 90.52.52.52.2 0.0.0.0

D. SATX(config-router)#administrative distance 91 51.51.51 0.0.0.0

E. SATX(config-router)#distance 89 51.51.51.1 0.0.0.0

F. SATX(config-router)#administrative distance 91 52.52.52.2 0.0.0.0

Answer: E


Question No: 11

When using SNMPv3 with NoAuthNoPriv, which string is matched for authentication?

A. username

B. password

C. community-string

D. encryption-key

Answer: A


Question No: 12

Which two OSPF router types can perform summarize in an OSPF network? (Choose two)

A. summary router

B. area border router

C. autonomous system boundary router

D. internal router

E. backbone router

Answer: B,C


P.S. Easily pass 300-101 Exam with Certleader Refined Dumps & pdf vce, Try Free: https://www.certleader.com/300-101-dumps.html (487 New Questions)