P.S. Best Quality 300-135 software are available on Google Drive, GET MORE: https://drive.google.com/open?id=1jym7Ys7sW0zD-gYW52PcqjgDlxEjQHCD
New Cisco 300-135 Exam Dumps Collection (Question 8 - Question 17)
New Questions 8
Which of the following is not a valid reason for a packet to be punted?
A. The TCAM has reached capacity
B. An unknown destination MAC address
C. A packet being discarded due to a security violation
D. A Telnet packet from a session being initiated with the switch
E. Routing protocols sending broadcast traffic
F. A packet belonging to a GRE tunnel
Answer: C
Explanation: Reference: CCNP TSHOOT Certification Guide: Advanced Cisco CatalystSwitch Troubleshooting
New Questions 9
A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch network and suggest resolutions to the problems.
PC2 in VLAN 200 is unable to ping the gateway address 172.16.200.1; identify the issue.
A. VTP domain name mismatch on SW4
B. VLAN 200 not configured on SW1
C. VLAN 200 not configured on SW2
D. VLAN 200 not configured on SW4
Answer: D
Explanation:
By looking at the configuration for SW2, we see that it is missing VLAN 200, and the u201cswitchport access vlan 200u201d command is missing under interface eth 0/0:
Topic 3, Troubleshooting EIGRP
18.You have been brought in to troubleshoot an EIGRP network. A network engineer has made configuration changes to the network rendering some locations unreachable. You are to locate the problem and suggest solution to resolve the issue.
R5 has become partially isolated from the remainder of the network. R5 can reach devices on directly connected networks but nothing else. What is causing the problem?
A. An outbound distribute list in R3
B. Inbound distribute lists in R5
C. An outbound distribute list in R6
D. Incorrect EIGRP routing process ID in R5
New Questions 10
Which three features are benefits of using GRE tunnels in conjunction with IPsec for building site-to-site VPNs? (Choose three.)
A. allows dynamic routing over the tunnel
B. supports multi-protocol (non-IP) traffic over the tunnel
C. reduces IPsec headers overhead since tunnel mode is used
D. simplifies the ACL used in the crypto map
E. uses Virtual Tunnel Interface (VTI) to simplify the IPsec VPN configuration
Answer: A,B,D
New Questions 11
The following commands are issued on a Cisco Router:
Router(configuration)#access-list 199 permit tcp host 10.1.1.1 host 172.16.1.1
Router(configuration)#access-list 199 permit tcp host 172.16.1.1 host 10.1.1.1 Router(configuration)#exit
Router#debug ip packet 199
What will the debug output on the console show?
A. All IP packets passing through the router
B. Only IP packets with the source address of 10.1.1.1
C. All IP packets from 10.1.1.1 to 172.16.1.1
D. All IP Packets between 10.1.1.1 and 172.16.1.1
Answer: D
Explanation:
In this example, the u201cdebug ip packetu201d command is tied to access list 199, specifying which IP packets should be debugged. Access list 199 contains two lines, one going from the host with IP address 10.1.1.1 to 172.16.1.1 and the other specifying all TCP packets from host 172.16.1.1 to 10.1.1.1.
New Questions 12
How long will a port remain in the listening state by default?
A. Depends on the number of switches in the spanning tree domain
B. 50 seconds
C. 15 seconds
D. Until the root directs it to start forwarding
E. 20 seconds
F. Depends on the pott speed
Answer: C
New Questions 13
The implementations group has been using the test bed to do a u2021proof-of-conceptu2021 that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
On which device is the fault condition located?
A. R1
B. R2
C. R3
D. R4
E. DSW1
F. DSW2
G. ASW1
H. ASW2
Answer: D
Explanation:
The EIGRP AS number configured on R4 is wrong.
New Questions 14
The implementations group has been using the test bed to do a u2021proof-of-conceptu2021 that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
On which device is the fault condition located?
A. R1
B. R2
C. R3
D. R4
E. DSW1
F. DSW2
G. ASW1
H. ASW2
Answer: A
Explanation:
On R1, for IPV4 authentication of OSPF the command is missing and required to configure-
----- ip ospf authentication message-digest
New Questions 15
The implementations group has been using the test bed to do a u2021proof-of-conceptu2021 that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, and FHRP services, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
The fault condition is related to which technology?
A. NTP
B. Switch-to-Switch Connectivity
C. Access Vlans
D. Port Security
E. VLAN ACL / Port ACL
F. Switch Virtual Interface
Answer: B
Explanation:
Since the Clients are getting an APIPA we know that DHCP is not working. However, upon closer examination of the ASW1 configuration we can see that the problem is not with DHCP, but the fact that the trunks on the port channels are only allowing VLANs 1-9, when the clients belong to VLAN 10. VLAN 10 is not traversing the trunk on ASW1, so the problem is with switch to switch connectivity, specifically the trunk configuration on ASW1.
New Questions 16
Several troubleshooters are about to work on the same problem. Which of the following troubleshooting methods would be most appropriate to make the best use of the troubleshooters1 time?
A. Bottom up
B. Component swapping
C. Top down
D. Shoot from the hip
E. Divide and conquer
F. Follow the traffic path
Answer: E
New Questions 17
The implementations group has been using the test bed to do a u2021proof-of-conceptu2021 that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
On which device is the fault condition located?
A. R1
B. R2
C. R3
D. R4
E. DSW1
F. DSW2
G. ASW1
Answer: A
Explanation:
On R1, we need to permit IP 209.65.200.222/30 under the access list.
Recommend!! Get the Best Quality 300-135 dumps in VCE and PDF From Dumpscollection, Welcome to download: http://www.dumpscollection.net/dumps/300-135/ (New 146 Q&As Version)