300-209 Exam - Implementing Cisco Secure Mobility Solutions (SIMOS)

certleader.com

Q1. Which feature is enabled by the use of NHRP in a DMVPN network? 

A. host routing with Reverse Route Injection 

B. BGP multiaccess 

C. host to NBMA resolution 

D. EIGRP redistribution 

Answer:

Q2. You are troubleshooting a site-to-site VPN issue where the tunnel is not establishing. After issuing the debug crypto ipsec command on the headend router, you see the following output. What does this output suggest? 

1d00h: IPSec (validate_proposal): transform proposal 

(port 3, trans 2, hmac_alg 2) not supported 

1d00h: ISAKMP (0:2) : atts not acceptable. Next payload is 0 

1d00h: ISAKMP (0:2) SA not acceptable 

A. Phase 1 policy does not match on both sides. 

B. The Phase 2 transform set does not match on both sides. 

C. ISAKMP is not enabled on the remote peer. 

D. The crypto map is not applied on the remote peer. 

E. The Phase 1 transform set does not match on both sides. 

Answer:

Q3. Which two statements comparing.ECC and RSA are true? (Choose two.) 

A. ECC can have the same security as RSA but with a shorter key size. 

B. ECC lags in performance when compared with RSA. 

C. Key generation in ECC is slower and less CPU intensive. 

D. ECC cannot have the same security as RSA, even with an increased key size. 

E. Key generation in ECC is faster and less CPU intensive. 

Answer: A,E 

Q4. You are troubleshooting a site-to-site VPN issue where the tunnel is not establishing. After issuing the debug crypto isakmp command on the headend router, you see the following output. What does this output suggest? 

1d00h: ISAKMP (0:1): atts are not acceptable. Next payload is 0 

1d00h: ISAKMP (0:1); no offers accepted! 

1d00h: ISAKMP (0:1): SA not acceptable! 

1d00h: %CRYPTO-6-IKMP_MODE_FAILURE. Processing of Main Mode failed with peer at 10.10.10.10 

A. Phase 1 policy does not match on both sides. 

B. The transform set does not match on both sides. 

C. ISAKMP is not enabled on the remote peer. 

D. There is a mismatch in the ACL that identifies interesting traffic. 

Answer:

Q5. Which three configuration parameters are mandatory for an IKEv2 profile? (Choose three.) 

A. IKEv2 proposal 

B. local authentication method 

C. match identity or certificate 

D. IKEv2 policy 

E. PKI certificate authority 

F. remote authentication method 

G. IKEv2 profile description 

H. virtual template 

Answer: B,C,F 

Q6. What does NHRP stand for? 

A. Next Hop Resolution Protocol 

B. Next Hop Registration Protocol C. Next Hub Routing Protocol 

D. Next Hop Routing Protocol 

Answer:

Q7. Refer to the exhibit. 

An administrator had the above configuration working with SSL protocol, but as soon as the administrator specified IPsec as the primary protocol, the Cisco AnyConnect client was not able to connect. What is the problem? 

A. IPsec will not work in conjunction with a group URL. 

B. The Cisco AnyConnect implementation does not allow the two group URLs to be the same. SSL does allow this. 

C. If you specify the primary protocol as IPsec, the User Group must be the exact name of the connection profile (tunnel group). 

D. A new XML profile should be created instead of modifying the existing profile, so that the clients force the update. 

Answer:

Q8. Consider this scenario. When users attempt to connect via a Cisco AnyConnect VPN session, the certificate has changed and the connection fails. 

What is a possible cause of the connection failure? 

A. An invalid modulus was used to generate the initial key. 

B. The VPN is using an expired certificate. 

C. The Cisco ASA appliance was reloaded. 

D. The Trusted Root Store is configured incorrectly. 

Answer:

Q9. Which two statements.about the Cisco ASA Clientless SSL VPN smart tunnels feature are true? (Choose two.) 

A. Smart tunnels are enabled on the secure gateway (Cisco ASA) for specific applications that run on the end client and work irrespective of which transport protocol the application uses. 

B. Smart tunnels require Administrative privileges to run on the client machine. 

C. A smart tunnel is a DLL that is pushed from the headend to the client machine after SSL VPN portal authentication and that is attached to smart-tunneled processes to route traffic through the SSL VPN session with the gateway. 

D. Smart tunnels offer better performance than the client-server plugins. 

E. Smart tunnels are supported on Windows, Mac, and Linux. 

Answer: C,D 

Q10. Which two statements regarding IKEv2 are true per RFC 4306? (Choose two.) 

A. It is compatible with IKEv1. 

B. It has at minimum a nine-packet exchange. 

C. It uses aggressive mode. 

D. NAT traversal is included in the RFC. 

E. It uses main mode. 

F. DPD is defined in RFC 4309. 

G. It allows for EAP authentication. 

Answer: D,G