Q1. Which feature must be configured for the VRRP-enabled router to regain the master VRRP status upon recovery from a failure?
A. priority
B. authentication
C. pre-emption
D. Stateful Switchover
Answer: C
Q2. Which option is a benefit of the vPC+ feature?
A. Cisco FabricPath is not required in the network domain.
B. This feature provides fault domain separation.
C. Nonfabric devices, such as a server or a classic Ethernet switch, can be connected to two fabric switches that are configured with vPC.
D. The control plane and management plane are combined into one logical plane.
Answer: C
Q3. What are two advantages of using Cisco FEX devices in the data center design? (Choose two.)
A. Traffic-forwarding decisions are made by the Cisco FEX device.
B. Cisco FEX devices must be upgraded when the parent switch is upgraded.
C. Traffic-forwarding decisions are made by the parent switch, resulting in easier troubleshooting and centralized management.
D. Cisco FEX devices do not have to be upgraded when the parent switch is upgraded, resulting in cost savings.
E. Cisco FEX devices can be part of two different VDCs.
Answer: C,D
Q4. Which protocol will not adhere to the design requirement of the control plane being either separated or combined within a virtualization technology?
A. FHRP
B. STP
C. CEF
D. NSF with SSO
Answer: B
Q5. A network engineer is building a LAN design that includes Cisco NAC. What two characteristics of an out-of-band NAC deployment are important to consider when evaluating it for the design? (Choose two.)
A. supported by a limited number of switch models
B. never in-line with user traffic
C. aggregate client traffic is constrained to NAC server port speed
D. recommended if sharing ports between IP phones and PCs
E. supports real IP gateway (routed mode)
Answer: A,D
Q6. Which three major points are important for network virtualization to separate logical networks on a shared physical infrastructure? (Choose three.)
A. VLANs
B. data plane
C. control plane
D. VPNs
E. VSANs
F. management plane
Answer: B,C,F
Q7. A network engineer must provide 40mb connections from the data center to the corporate office and two remote offices. What WAN connectivity option will outsource the routing in cooperation with the service provider?
A. Ethernet Private Line
B. Ethernet Multipoint Service
C. MPLS VPN
D. VPLS
Answer: C
Q8. Which two statements about both FCIP and iSCSI are correct? (Choose two.)
A. They support file-level storage for remote devices.
B. They require high throughput with low latency and low jitter.
C. Their purpose is to provide connectivity between host and storage.
D. They support block-level storage for remote devices.
E. Their purpose is to provide connectivity between separate wide-area SANs.
Answer: B,D
Q9. Click the Exhibit button.
Refer to the exhibit. Which Layer 2 feature detects a link failure between the switch and router B that decreases OSPF reconvergence to approximately 50 milliseconds?
A. BFD
B. UDLD
C. RSTP
D. PVST+
Answer: A
Q10. In a collapsed core design, which three benefits are provided by a second-generation Cisco MDS director? (Choose three.)
A. a higher fan-out ratio
B. fully redundant switches
C. 100 percent port efficiency
D. all ISLs contained within a single chassis
E. higher latency and throughput than a core-edge design switch
Answer: B,C,D