Q1. An engineer used an interface group under the SSID configuration, but noticed that a test client is getting an IP assigned in a different VLAN from the DHCP server. Which two options override the interface group configuration on the SSID? (Choose two.)
A. static VLAN on client
B. ACL
C. AP group
D. static IP on client
E. MAC filtering
F. RF group
G. AAA override
Answer: C,G
Q2. What is the best practice for setting the WLC v7.0 use of WLAN QoS settings to support SIP phones on a VoWLAN?
A. Configure SIP with static CAC only with SIP call snooping.
B. Configure SIP with static CAC only without SIP call snooping.
C. Configure SIP with load-based CAC only with SIP call snooping.
D. Configure SIP with load-based CAC only without SIP call snooping.
E. Configure SIP with load-based CAC and TSPEC only with SIP call snooping.
Answer: A
Q3. When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.)
A. Upstream marked as Best Effort.
B. Upstream marked as ToS CS4.
C. Upstream marked as DSCP EF.
D. Downstream marked as DSCP EF.
E. Downstream marked as Best Effort.
F. Downstream marked as Silver.
Answer: C,E
Q4. An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task?
A. Change the AVC application WebEx-app-sharing to mark
B. Create an ACL for WebEx.
C. Change the WLAN reserved bandwidth for WebEx.
D. Create an AVC profile for WebEx marked with a lower DSCP value
Answer: A
Q5. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking?
A. Uses existing LWAPP-enabled Cisco Unified Networking components.
B. Proprietary client hardware or software is required.
C. Better accuracy and precision.
D. Reduced calibration effort.
Answer: B
Q6. What are two functions of the RAP in a mesh network? (Choose two.)
A. It provides a wired connection for the wireless mesh APs.
B. It adds capacity and resilience to a mesh area.
C. it creates a centralized management location for the mesh network.
D. it reduces the hop count to the wireless network that is connected to the edge.
E. it routes traffic from the wireless mesh to the wired network.
Answer: B,D
Q7. Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.)
A. |f Ethernet and wireless are available, it attempts to discover only via Ethernet.
B. if Ethernet is disconnected, it attempts to connect wirelessly using AWPP.
C. if only wireless is available and it is configured as a MAP, it does not attempt to connect to a WLC.
D. If Ethernet and wireless are available, it uses Ethernet first. If it cannot connect via Ethernet, then it chooses wireless.
E. |f Ethernet is disconnected, it attempts to connect wirelessly using the configured DHCP option.
Answer: A,B
Q8. By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead?
A. 10 Seconds
B. 60 Seconds
C. 15 Seconds
D. 30 Seconds
Answer: D
Q9. A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference. Which interface group configuration should be used?
A. One interface with /20 mask
B. Two interfaces with /21 mask
C. Four interfaces with /22 mask
D. Eight interfaces with /23 mask
Answer: D
Q10. A customer requires that the remote site be able to utilize local servers when the AP is in WAN-down (standalone mode). Which AP mode must be configured on the wireless controller?
A. SE-Connect
B. Monitor
C. Local
D. FlexConnect
E. Sniffer
F. Rogue Detector
Answer: D