Your success in Cisco 300-410 is our sole target and we develop all our 300-410 braindumps in a way that facilitates the attainment of this target. Not only is our 300-410 study material the best you can find, it is also the most detailed and the most updated. 300-410 Practice Exams for Cisco Cisco Other Exam 300-410 are written to the highest standards of technical accuracy.
Free 300-410 Demo Online For Cisco Certifitcation:
NEW QUESTION 1
Refer to the exhibit.
An administrator noticed that after a change was made on R1, the timestamps on the system logs did not match the clock. What is the reason for this error?
- A. An authentication error with the NTP server results in an incorrect timestamp.
- B. The keyword localtime is not defined on the timestamp service command.
- C. The NTP server is in a different time zone.
- D. The system clock is set incorrectly to summer-time hours.
Answer: D
NEW QUESTION 2
Refer to the exhibits.
Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN. Which two commands are missing? (Choose two.)
- A. The ip nhrp redirect command is missing on the spoke routers.
- B. The ip nhrp shortcut command is missing on the spoke routers.
- C. The ip nhrp redirect command is missing on the hub router.
- D. The ip nhrp shortcut command is missing on the hub router.
- E. The ip nhrp map command is missing on the hub router.
Answer: BC
NEW QUESTION 3
Which transport layer protocol is used to form LDP sessions?
- A. UDP
- B. SCTP
- C. TCP
- D. RDP
Answer: C
NEW QUESTION 4
Refer to the exhibit.
What does the imp-null tag represent in the MPLS VPN cloud?
- A. Pop the label
- B. Impose the label
- C. Include the EXP bit
- D. Exclude the EXP bit
Answer: C
NEW QUESTION 5
Refer to the exhibit.
The output of the trace route from R5 shows a loop in the network. Which configuration prevents this loop?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: B
NEW QUESTION 6
While working with software images, an engineer observes that Cisco DNA Center cannot upload its software image directly from the device. Why is the image not uploading?
- A. The device must be resynced to Cisco DNA Center.
- B. The software image for the device is in install mode.
- C. The device has lost connectivity to Cisco DNA Center.
- D. The software image for the device is in bundle mode
Answer: B
NEW QUESTION 7
Drag and drop the MPLS terms from the left onto the correct definitions on the right.
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 8
Refer to the exhibit.
Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: A
NEW QUESTION 9
Refer to the exhibit.
An engineer is trying to configure local authentication on the console line, but the device is trying to authenticate using TACACS+. Which action produces the desired configuration?
- A. Add the aaa authentication login default none command to the global configuration.
- B. Replace the capital “C” with a lowercase “c” in the aaa authentication login Console local command.
- C. Add the aaa authentication login default group tacacs+ local-case command to the global configuration.
- D. Add the login authentication Console command to the line configuration
Answer: D
NEW QUESTION 10
Drag and drop the packet types from the left onto the correct descriptions on the right.
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 11
Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right.
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 12
Refer to the exhibit.
In which circumstance does the BGP neighbor remain in the idle condition?
- A. if prefixes are not received from the BGP peer
- B. if prefixes reach the maximum limit
- C. if a prefix list is applied on the inbound direction
- D. if prefixes exceed the maximum limit
Answer: D
NEW QUESTION 13
Which statement about route distinguishers in an MPLS network is true?
- A. Route distinguishers allow multiple instances of a routing table to coexist within the edge router.
- B. Route distinguishers are used for label bindings.
- C. Route distinguishers make a unique VPNv4 address across the MPLS network.
- D. Route distinguishers define which prefixes are imported and exported on the edge router.
Answer: C
NEW QUESTION 14
An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?
- A. sudo maglev-config update
- B. sudo maglev install config update
- C. sudo maglev reinstall
- D. sudo update config install
Answer: A
NEW QUESTION 15
Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?
- A. shared risk link group-disjoint
- B. linecard-disjoint
- C. lowest-repair-path-metric
- D. interface-disjoint
Answer: A
NEW QUESTION 16
Drag and drop the DHCP messages from the left onto the correct uses on the right.
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 17
Refer to the exhibit.
An engineer is trying to redistribute OSPF to BGP, but not all of the routes are redistributed. What is the reason for this issue?
- A. By default, only internal routes and external type 1 routes are redistributed into BGP
- B. Only classful networks are redistributed from OSPF to BGP
- C. BGP convergence is slow, so the route will eventually be present in the BGP table
- D. By default, only internal OSPF routes are redistributed into BGP
Answer: A
NEW QUESTION 18
Refer to the exhibit.
ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to
achieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?
- A. Start-time 00:00
- B. Start-time 0
- C. Start-time immediately
- D. Start-time now
Answer: D
NEW QUESTION 19
Refer to the exhibit.
Which subnet is redistributed from EIGRP to OSPF routing protocols?
- A. 10.2.2.0/24
- B. 10.1.4.0/26
- C. 10.1.2.0/24
- D. 10.2.3.0/26
Answer: A
NEW QUESTION 20
Refer to the exhibit.
An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen. What is the reason for this?
- A. Dynamic routing protocols always have priority over static routes.
- B. The metric of the OSPF route is lower than the metric of the static route.
- C. The configured AD for the static route is higher than the AD of OSPF.
- D. The syntax of the static route is not valid, so the route is not considered.
Answer: C
NEW QUESTION 21
......
P.S. Easily pass 300-410 Exam with 58 Q&As DumpSolutions Dumps & pdf Version, Welcome to Download the Newest DumpSolutions 300-410 Dumps: https://www.dumpsolutions.com/300-410-dumps/ (58 New Questions)