Testking offers free demo for 300-430 exam. "Implementing Cisco Enterprise Wireless Networks (ENWLSI)", also known as 300-430 exam, is a Cisco Certification. This set of posts, Passing the Cisco 300-430 exam, will help you answer those questions. The 300-430 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 300-430 exams and revised by experts!
Free demo questions for Cisco 300-430 Exam Dumps Below:
NEW QUESTION 1
A customer is experiencing performance issues with its wireless network and asks a wireless engineer to provide information about all sources of interference and their impacts to the wireless network over the past few days. Where can the requested information be accessed?
- A. CleanAir reports on Cisco Prime Infrastructure
- B. Performance reports on Cisco Prime Infrastructure
- C. Interference Devices reports on Cisco Wireless LAN Controller
- D. Air Quality reports on Cisco Wireless LAN Controller
Answer: A
NEW QUESTION 2
All APs are receiving multicast traffic, instead of only the APs that need it. What is the cause of this problem?
- A. The multicast group includes all APs
- B. The wrong multicast address was used
- C. The multicast group is assigned the wrong VLAN
- D. Multicast IGMP snooping is not enabled
Answer: D
NEW QUESTION 3
A new MSE with wIPS service has been installed and no alarm information appears to be reaching the MSE from controllers. Which protocol must be allowed to reach the MSE from the controllers?
- A. SOAP/XML
- B. NMSP
- C. CAPWAP
- D. SNMP
Answer: A
NEW QUESTION 4
Refer to the exhibit.
Which two items must be supported on the VoWLAN phones to take full advantage of this WLAN configuration? (Choose two.)
- A. TSPEC
- B. SIFS
- C. 802.11e
- D. WMM
- E. APSD
Answer: CD
NEW QUESTION 5
What is the default NMSP echo interval between Cisco MSE and a Wireless LAN Controller?
- A. 10 seconds
- B. 15 seconds
- C. 30 seconds
- D. 60 seconds
Answer: B
Explanation:
Reference: https://www.cisco.com/en/US/docs/wireless/mse/3350/6.0/CAS/configuration/guide/msecg_ch4_CAS.html
NEW QUESTION 6
Which command set configures a Cisco Catalyst 9800 Series Wireless Controller so that the client traffic enters the network at the AP switch port?
A.
B.
- A.
- B.
Answer: B
NEW QUESTION 7
An engineer is configuring multicast for wireless for an all-company video meeting on a network using EIGRP and BGP within a single domain from a single source. Which type of multicast routing should be implemented?
- A. Protocol Independent Multicast Dense Mode
- B. Source Specific Multicast
- C. Multicast Source Discovery Protocol
- D. Protocol Independent Multicast Sparse Mode
Answer: D
NEW QUESTION 8
A corporation has recently implemented a BYOD policy at their HQ. Which two risks should the security director be concerned about? (Choose two.)
- A. network analyzers
- B. malware
- C. lost and stolen devices
- D. keyloggers
- E. unauthorized users
Answer: BC
NEW QUESTION 9
An engineer completed the basic installation for two Cisco CMX servers and is in the process of configuring high availability, but it fails. Which two statements about the root of the issue are true? (Choose two.)
- A. The Cisco CMX instances are installed in the same subnet.
- B. The types of the primary and secondary Cisco CMX installations differ.
- C. The delay between the primary and secondary instance is 200 ms.
- D. The sizes of the primary and secondary Cisco CMX installations differ.
- E. Both Cisco CMX installations are virtual.
Answer: BD
NEW QUESTION 10
An IT team is growing quickly and needs a solution for management device access. The solution must authenticate users from an external repository instead of the current local on the WLC, and it must also identify the user and determine what level of access users should have. Which protocol do you recommend to achieve these goals?
- A. network policy server
- B. RADIUS
- C. TACACS+
- D. LDAP
Answer: C
NEW QUESTION 11
When using a Cisco Catalyst 9800 Series Wireless Controller, which statement about AutoQoS is true?
- A. It has a set of predefined profiles that you cannot modify further
- B. It matches traffic and assigns each matched packet to QoS groups
- C. It automates deployment of wired QoS and makes wireless QoS implementation easier
- D. It allows the output policy map to put specific QoS queues into specific subgroups
Answer: B
NEW QUESTION 12
A Cisco WLC has been added to the network and Cisco ISE as a network device, but authentication is failing. Which configuration within the network device configuration should be verified?
- A. SNMP RO community
- B. device interface credentials
- C. device ID
- D. shared secret
Answer: D
NEW QUESTION 13
What is an important consideration when implementing a dual SSID design for BYOD?
- A. After using the provisioning SSID, an ACL that used to make the client switch SSIDs forces the user to associate and traverse the network by MAC filtering.
- B. If multiple WLCs are used, the WLAN IDs must be exact for the clients to be provisioned and traverse the network correctly.
- C. SSIDs for this setup must be configured with NAC State-RADIUS NAC for the clients to authenticate with Cisco ISE, or with NAC State-ISE NAC for Cisco ISE to associate the client.
- D. One SSID is for provisioning and the other SSID is for gaining access to the networ
- E. The use of an ACL should not be enforced to make the client connect to the REAL SSID after provisioning.
Answer: D
NEW QUESTION 14
An engineer must use Cisco AVC on a Cisco WLC to prioritize Cisco IP cameras that use the wireless network. Which element do you configure in a rule?
- A. permit-ACL
- B. WMM required
- C. mark
- D. rate-limit
Answer: C
NEW QUESTION 15
A wireless engineer must implement a corporate wireless network for a large company in the most efficient way possible. The wireless network must support 32 VLANs for 300 employees in different departments. Which solution must the engineer choose?
- A. Configure a second WLC to support half of the APs in the deployment.
- B. Configure one single SSID and implement Cisco ISE for VLAN assignment according to different user roles.
- C. Configure different AP groups to support different VLANs, so that all of the WLANs can be broadcast on both radios.
- D. Configure 16 WLANs to be broadcast on the 2.4-GHz band and 16 WLANs to be broadcast on the 5.0-GHz band.
Answer: B
NEW QUESTION 16
An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task?
- A. Change the WLAN reserved bandwidth for WebEx
- B. Create an AVC profile for WebEx
- C. Create an ACL for WebEx
- D. Change the AVC application WebEx-app-sharing to mark
Answer: B
NEW QUESTION 17
Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Series Wireless Controller?
- A. RF Profile
- B. Flex Profile
- C. Policy Profile
- D. AP Join ProfileCorrect
Answer: B
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/flexconnect.html
NEW QUESTION 18
What is the difference between PIM sparse mode and PIM dense mode?
- A. Sparse mode supports only one switc
- B. Dense mode supports multiswitch networks.
- C. Sparse mode flood
- D. Dense mode uses distribution trees.
- E. Sparse mode uses distribution tree
- F. Dense mode floods.
- G. Sparse mode supports multiswitch network
- H. Dense mode supports only one switch.
Answer: C
NEW QUESTION 19
Which two restrictions are in place with regards to configuring mDNS? (Choose two.)
- A. mDNS uses only UDP port 5436 as a destination port.
- B. mDNS cannot use UDP port 5353 as the destination port.
- C. mDNS is not supported on FlexConnect APs with a locally switched WLAN.
- D. Controller software must be newer than 7.0.6+.
- E. mDNS is not supported over IPv6.
Answer: CD
NEW QUESTION 20
Branch wireless users report that they can no longer access services from head office but can access services locally at the site. New wireless users can associate to the wireless while the WAN is down. Which three elements (Cisco FlexConnect state, operation mode, and authentication method) are seen in this scenario? (Choose three.)
- A. authentication-local/switch-local
- B. WPA2 personal
- C. authentication-central/switch-central
- D. lightweight mode
- E. standalone mode
- F. WEB authentication
Answer: ABE
NEW QUESTION 21
An engineer must implement rogue containment for an SSID. What is the maximum number of APs that should be used for containment?
- A. 1
- B. 2
- C. 3
- D. 4
Answer: D
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/technology/roguedetection_deploy/Rogue_Detection.html
NEW QUESTION 22
Which feature on the Cisco Wireless LAN Controller must be present to support dynamic VLAN mapping?
- A. FlexConnect ACL
- B. VLAN name override
- C. CCKM/OKC
- D. AAA override
Answer: D
NEW QUESTION 23
Refer to the exhibit. A network administrator deploys the DHCP profiler service in two ISE servers: 10.3.10.101 and 10.3.10.102. All BYOD devices connecting to WLAN on VLAN63 have been incorrectly profiled and are assigned as unknown profiled endpoints. Which action efficiently rectifies the issue according to Cisco recommendations?
- A. Nothing needed to be added on the Cisco WLC or VLAN interfac
- B. The ISE configuration must be fixed.
- C. Disable DHCP proxy on the Cisco WLC.
- D. Disable DHCP proxy on the Cisco WLC and run the ip helper-address command under the VLAN interface to point to DHCP and the two ISE servers.
- E. Keep DHCP proxy enabled on the Cisco WLC and define helper-address under the VLAN interface to point to the two ISE servers.
Answer: C
NEW QUESTION 24
......
P.S. Dumpscollection now are offering 100% pass ensure 300-430 dumps! All 300-430 exam questions have been updated with correct answers: http://www.dumpscollection.net/dumps/300-430/ (60 New Questions)