3V0-42.20 Exam - Advanced Design VMware NSX-T Data Center

certleader.com

Master the 3V0-42.20 Advanced Design VMware NSX-T Data Center content and be ready for exam day success quickly with this Examcollection 3V0-42.20 exam answers. We guarantee it!We make it a reality and give you real 3V0-42.20 questions in our VMware 3V0-42.20 braindumps.Latest 100% VALID VMware 3V0-42.20 Exam Questions Dumps at below page. You can use our VMware 3V0-42.20 braindumps and pass your exam.

Online VMware 3V0-42.20 free dumps demo Below:

NEW QUESTION 1
What is a design justification for a solution with 3 NSX Manager nodes deployed in a 4 ESXi cluster Management Cluster? (Choose the best answer.)

  • A. NSX Controllers are separated from NSX Managers allowing 6 ESXi servers to host them.
  • B. NSX Management Plane and Control Plane will be reduced to a single point of failure.
  • C. Compute consumption guarantees NSX Manager nodes can be run on the same ESXi host.
  • D. Single point of failure on Control Plane and Management Plane will be mitigated.

Answer: B

NEW QUESTION 2
An administrator is asked to improve Recovery Point Objective (RPO) and Recovery Time Objective (RTO) for Disaster Recovery (DR) in their company network. The network has a primary site and a secondary site. The ability to support outages with minimum loss of connectivity to the company??s core application is a priority.
Which design should the administrator recommend? (Choose the best answer.)

  • A. NSX-T Data Center using an Orchestrator to recover VMs across sites.
  • B. NSX-T Data Center using Federation and dependencies set between primary and secondary sites.
  • C. NSX-T Data Center using a registered third-party DR solution.
  • D. NSX-T Data Center using built-in standard automation DR and secondary site recovery setup.

Answer: B

NEW QUESTION 3
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:
3V0-42.20 dumps exhibit Customer currently has a single 10 host vSphere cluster.
3V0-42.20 dumps exhibit Customer wants to improve network security and automation.
3V0-42.20 dumps exhibit Current cluster utilization and business policies prevent changing the existing vSphere deployment.
3V0-42.20 dumps exhibit High-availability is important to the customer.
Which three selections should the architect include in their design? (Choose three.)

  • A. Apply vSphere DRS VM-Host anti-affinity rules to the virtual machines of the NSX-T Edge cluster.
  • B. Deploy at least two NSX-T Edge virtual machines in the vSphere cluster.
  • C. Deploy the NSX Controllers in the management cluster.
  • D. Apply vSphere Distributed Resource Scheduler (vSphere DRS) VM-Host anti-affinity rules to NSX Managers.
  • E. Remove 2 hosts from the cluster and create a new edge cluster.
  • F. Remove vSphere DRS VM-Host affinity rules to the NSX-T Controller VMs.

Answer: ACE

NEW QUESTION 4
An NSX-T architect is working with a customer who wants to improve performance and future-proof their workloads with a multi-site architecture.
A current-state analysis captured this information:
3V0-42.20 dumps exhibit Latency between sites is 160ms.
3V0-42.20 dumps exhibit Bandwidth is 2Gbps.
3V0-42.20 dumps exhibit The MTU is 1600.
What two VMware design recommendations should the architect recommend to the organization to achieve future-proofing? (Choose two.)

  • A. MTU is recommended to be 9000.
  • B. MTU must be at least 1700.
  • C. Bandwidth must be at least 10Gbps.
  • D. Latency RTT is acceptable.
  • E. Latency must be less than 150ms.

Answer: AE

NEW QUESTION 5
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:
3V0-42.20 dumps exhibit There is a performance based SLA for East ?C West traffic.
3V0-42.20 dumps exhibit The business critical applications require prioritization of their traffic.
3V0-42.20 dumps exhibit One of the services is a file share and has a high demand for bandwidth.
Which selection should the architect include in their design? (Choose the best answer.)

  • A. Review average North/South traffic from the core switches and firewall.
  • B. Include a segment QoS profile and review the impact of utilizing this feature.
  • C. Meet with the organization??s application team to get additional information.
  • D. Monitor East-West traffic throughout normal business cycles.

Answer: B

NEW QUESTION 6
Which three assessment findings are part of a Conceptual Design? (Choose three.)

  • A. risks
  • B. host names
  • C. justifications
  • D. constraints
  • E. assumptions
  • F. vendor model

Answer: ACD

NEW QUESTION 7
An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop:
3V0-42.20 dumps exhibit Current hypervisor of choice is KVM.
3V0-42.20 dumps exhibit Cost reduction is important.
Which two selections should the architect recommend to the organization? (Choose two.)

  • A. Deploy Edge VM Nodes using ISO.
  • B. Deploy NSX Manager using OVF.
  • C. Deploy NSX Manager using QCOW2.
  • D. Deploy bare metal Edge Nodes.
  • E. Deploy Edge VM Nodes on KVM.

Answer: CD

NEW QUESTION 8
Which two resources can be used by an NSX architect during the Assessment Phase? (Choose two.)

  • A. vRealize Network Insight
  • B. VMware Validated Design
  • C. VMware customer references
  • D. key stakeholder interviews
  • E. application licensing

Answer: AE

NEW QUESTION 9
According to the Discover Task of the Engagement Lifecycle, which statement would be classified as a risk? (Choose the best answer.)

  • A. Enough power and cooling capacity is available in each rack in the data center.
  • B. To retain certification to provide financial services to end customers, PCI-DSS audits need to be passed.
  • C. A merger and acquisition process was recently completed and new company on-boarding is not completed.
  • D. Due to existing contracts and purchase agreements, the existing server hardware needs to be reused.

Answer: B

NEW QUESTION 10
An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution. Which three selections are requirements documented by an architect? (Choose three.)

  • A. Aggregate N-S throughput at any given time should be at least 10G.
  • B. All traffic should recover in the event of Host/Rack/ToR failure.
  • C. Hardware is 5 years old and new hardware is already purchased.
  • D. SAN storage has enough capacity to build the new infrastructure.
  • E. Business critical applications should have an SLA of 99.99%.
  • F. The Development Team are heavy on API usage.

Answer: ACF

NEW QUESTION 11
What would an architect recommend to a customer that wants to extend management to an additional data center through Layer 2, but does not want to add additional NSX-T licensing? (Choose the best answer.)

  • A. Deploy a standalone NSX Controller.
  • B. Deploy a standalone NSX Manager.
  • C. Deploy a standalone Edge as the IPSec VPN.
  • D. Deploy Autonomous Edge as the L2 VPN client.

Answer: D

NEW QUESTION 12
An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop:
3V0-42.20 dumps exhibit The company will use a Leaf and Spine physical network architecture with Layer 3 gateways for top of rack switches.
3V0-42.20 dumps exhibit The company is planning to deploy 120 ESX hosts across 10 racks.
3V0-42.20 dumps exhibit There will be a total of a 12 clusters where each cluster has one host per rack.
What should the architect recommend to allow applications to run on any host in the cluster? (Choose the best answer.)

  • A. Deploy all application networks on NSX segments.
  • B. Deploy an L2 VPN to allow the networks to extend to each host.
  • C. Deploy a Tier-0 gateway per Rack and configure BGP between racks.
  • D. Deploy a Tier-1 gateway per Rack and configure BGP between racks.

Answer: D

NEW QUESTION 13
Which two protocols are typically used for multicast in a NSX-T Data Center environment? (Choose two.)

  • A. PIM Full Form
  • B. PIM Dense Mode
  • C. IGMPv2
  • D. PIM Sparse mode
  • E. IGMPv3

Answer: CD

NEW QUESTION 14
Refer to the exhibits.
Design Option1:
3V0-42.20 dumps exhibit
Design Option 2:
3V0-42.20 dumps exhibit
Design Option 3:
3V0-42.20 dumps exhibit
Design Option 4:
3V0-42.20 dumps exhibit
An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution. The conceptual design includes these requirements, assumptions, constraints, and risks:
3V0-42.20 dumps exhibit Critical applications must run across sites without changing IP address.
3V0-42.20 dumps exhibitRTO/RPO must be reduced for recovery of applications on secondary site.
3V0-42.20 dumps exhibit IT Teams require automation tools for configuration.
Which Conceptual Design would the architect recommend to the customer? (Choose the best answer.)

  • A. Design Option 4
  • B. Design Option 2
  • C. Design Option 1
  • D. Design Option 3

Answer: C

NEW QUESTION 15
An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:
3V0-42.20 dumps exhibit There is a critical application used by the Finance Team.
3V0-42.20 dumps exhibit The critical application has an availability and recoverability SLA of 99.999%.
3V0-42.20 dumps exhibit The critical application is sensitive to network changes.
Which two selections should an architect include in their design? (Choose two.)

  • A. Configure Tier-0 gateway for eBGP and ECMP.
  • B. Configure Tier-1 gateway for eBGP and ECMP.
  • C. Enable BFD on Tier-0 gateway.
  • D. Install and configure hosts with 100Gbps physical NICs.
  • E. Configure multiple static routes on Tier-1 gateway.

Answer: BD

NEW QUESTION 16
An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop:
3V0-42.20 dumps exhibit Any proposed solution must provide low latency.
3V0-42.20 dumps exhibit Any proposed solution must provide high throughput.
3V0-42.20 dumps exhibit Customer is running stock trading applications.
Which two selections should the architect recommend to meet high-performance workload requirements?
(Choose two.)

  • A. Leverage ESXi as the compute host.
  • B. Use LACP for all uplink profiles.
  • C. Leverage KVM as the compute host.
  • D. Enable enhanced data path mode on the N-VDS.
  • E. Enable latency sensitivity mode on the N-VDS.

Answer: AD

NEW QUESTION 17
An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution. This information was gathered by the architect during the Discover Task of the Enagagement Lifecycle:
3V0-42.20 dumps exhibit There are applications which use IPv6 addressing.
3V0-42.20 dumps exhibit Network administrators are not familiar with NSX-T Data Center solutions.
3V0-42.20 dumps exhibit Hosts can only be configured with two physical NICs.
3V0-42.20 dumps exhibit There is an existing management cluster to deploy the NSX-T components.
3V0-42.20 dumps exhibit Dynamic routing should be configured between the physical and virtual network.
3V0-42.20 dumps exhibit There is a storage array available to deploy NSX-T components.
Which constraint was documented by the architect? (Choose the best answer.)

  • A. Dynamic routing should be configured between the physical and virtual network.
  • B. There are applications which use IPv6 addressing.
  • C. Hosts can only be configured with two physical NICs.
  • D. There are enough CPU and memory resources in the existing management cluster.

Answer: A

NEW QUESTION 18
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:
3V0-42.20 dumps exhibit There isn??t much budget available for a new off shore site.
3V0-42.20 dumps exhibit The new site is decentralized and no communication with the main data center is required.
3V0-42.20 dumps exhibit The design will need to cater for availability, upgrades, and failure scenarios.
3V0-42.20 dumps exhibit N+1 must be maintained at all times.
Which three selections should the architect recommend in their design? (Choose three.)

  • A. Separate the hosts physical NICs for VSS and N-VDS.
  • B. Make all pNICs part of N-VDS and VMKs will be migrated.
  • C. Collapse the Management/Edge/Compute cluster.
  • D. Install a minimum 4 ESXi hosts in the site.
  • E. A Shared Edge/Management cluster and one for Compute.
  • F. Install a minimum of 3 ESXi hosts in the site.

Answer: ABC

NEW QUESTION 19
An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution. Which risk is documented by an architect? (Choose the best answer.)

  • A. The security team has a firewall communication matrix documented.
  • B. The team is not trained for NSX-T but have a very strong experience with vSphere.
  • C. Open communication between different application tiers is not allowed.
  • D. Aggregate N-S throughput at any given time should be at least 10G.

Answer: B

NEW QUESTION 20
A customer deploying NSX-T Data Center requires role based access controls be enforced in NSX Manager with these requirements:
3V0-42.20 dumps exhibit identity platform must be highly available
3V0-42.20 dumps exhibit authentication must be performed by customer??s existing SAML identity provider
3V0-42.20 dumps exhibit MFA must be performed by administrator to gain access to NSX Manager
Which identity deployments would meet the customer??s requirements? (Choose the best answer.)

  • A. NSX Manager OAuth 2.0 registered to a 3-node Active Directory Federation Services cluster.
  • B. NSX Manager OAuth 2.0 registered to a 2-node VMware Identity Manager cluster.
  • C. NSX Manager OAuth 2.0 registered to a 2-node Active Directory Federation Services cluster
  • D. NSX Manager OAuth 2.0 registered to a 3-node VMware Identity Manager cluster.

Answer: D

NEW QUESTION 21
......

Thanks for reading the newest 3V0-42.20 exam dumps! We recommend you to try the PREMIUM 2passeasy 3V0-42.20 dumps in VCE and PDF here: https://www.2passeasy.com/dumps/3V0-42.20/ (57 Q&As Dumps)