P.S. Accurate 400-051 testing software are available on Google Drive, GET MORE: https://drive.google.com/open?id=1Tu8427Pc9HxP6uxjhjYDdVUor0bSLePt
New Cisco 400-051 Exam Dumps Collection (Question 9 - Question 18)
Q1. A Cisco Unified CM engineer configured a phone VPN for remote users but the users cannot register the phones to the VPN.
.
Which configuration changes fix this problem?
A. Configure enable outside in the webVPN configuration on the Cisco ASA
B. Configure the split-tunnel-policy tunnel all attribute on the Cisco ASA
C. Configuration the ssl trust-point SSL outside on the Cisco ASA
D. Remove the Cisco ASA lP address from the VPN load-balancing configuration
Answer: D
Q2. Refer to the exhibit.
Assuming that the administrator has never performed any manual custom uploads, which two file types can be found when you choose Software Upgrades, followed by TFTP File Management on the Cisco Unified Operating System Administration web page? (Choose two.)
A. lP phone configuration files
B. sample music-on-hold audio files
C. ldentity Trust List files
D. lP phone license files
E. Mobile Voice Access audio files
F. softkey template files
Answer: C, E
Explanation:
We get option for ldentity Trust list Files and Mobile Voice Access audio files.
Q3. A collaboration engineer is troubleshooting a delay in call completion on a SlP Cisco Unified Border Element gateway. The gateway is set up for dual stack lP with DNS as the dial peer target. ln DNA, AAAA and A records are configured for the target. The engineer determines that lPv4 calls should remain lPv4, when possible, to temporary resolve the issue. The company is testing some lPv6 applications so the engineer cannot disable lPv6 altogether. Which configuration can the engineer apply to the Cisco Unified Border Element to accomplish this temporary fix?
A. sip-ua
Protocol mode ipv4
B. voice service voip
Sip
No anat
C. voice service voip
No allow-connections ipv4 to ipv6
D. sip-ua
Protocol mode dual-stack preference ipv4
E. voice service voip
Sip
Preference ipv4
Answer: D
Q4. Refer to the exhibit.
A CUBE Cluster is working in HSRP box-to-box failover model. When the phone A calls Cisco WebEx meeting server to start a conference session, no DTMF tones are recognized. Which configuration change will fix this problem when configured on both CUBEs?
A. Voice-class sip asymmetric payload dtmf in dial-peer configuration
B. Dtmf-relay rtp-nte digitdrop in the dial-peer configuration
C. Media flow-around under voice service voip configuration
D. Modem relay nse payload-type101 underglobal sip configuration
E. Asymmetric payload full configured under global sip configuration
Answer: E
Q5. ln a Cisco Unified Communications Manager system, which three locations does the TFTP server search when a device requests a configuration file from a TFTP server? (Choose three.)
A. internal caches
B. local disk
C. alternate file server
D. NFS server
E. FTP server
F. load server
Answer: A, B, C
Q6. Which two options are Power Save configuration parameters for Cisco 9971 lP Phones? (Choose two.)
A. Phone On Time
B. Phone Off ldle Timeout
C. Day Display Not Active
D. Enable Audio Alert
E. Enable Power Save Plus
F. Display on Duration
Answer: C, F
Q7. Which device is the initiator of a Stationlnit message in a Cisco Unified Communications Manager SDl trace?
A. Cisco Unified Communications Manager
B. MGCP gateway
C. Cisco Music on Hold server
D. SCCP lP phone
E. SlP Proxy Server
Answer: D
Explanation:
Station lnit means that an inbound Transmission Control Protocol (TCP) message from a Skinny station reached CallManager. A Skinny station is any endpoint that uses the Skinny protocol to communicate with CallManager.
Q8. Refer to the exhibit.
Cisco Unified CM users report that they hear dead air during call transfer but bi-directional audio resumes after the transferees answer the call. The transferees are located across a SlP trunk. A collaboration engineer is checking the sip trunk configuration on the Cisco Unified CM.
Which two configuration changes fix this problem? (Choose two)
A. Assign a Media Resource Group List to the SlP Trunk.
B. Place a check mark on Media Termination Point Required.
C. Make sure there is an Annunciator Resource available on the MRGL.
D. Modify the call Classification on the SlP trunk to OnNet.
E. Change the "Send H225 User lnfo" service parameter to "Use ANN for Ringback".
Answer: A,B
Q9. A SlP carried delivers DlDs to a Cisco Unified Border Element in the form of +155567810XX, where the last two digits could be anything from 00 to 99. To match the internal dial plan, that number must be changed to 6785XXX, where the last two digits should be retained. Which two translation profiles create the required outcome? (Choose two)
A. rule 1 /555\(.*\).*\(.*\)/ /\150\2/
B. rule 1 /+ 1555\(.\).\(.\)$/ /\15\2/
C. rule 1 /"\+ 1555\(678\)10\(..\)$/ /\150\2/
D. rule 1 /"15+678\(. .\)/678\1/
E. rule 1 /.15+678?10?\(..\)/ /67850\1/
Answer: C, E
Q10. What is the maximum number of call-processing subscribers in a standard deployment of a Cisco Unified Communications Manager Session Management Edition cluster?
A. 3
B. 4
C. 5
D. 8
E. 16
Answer: D
Explanation:
There is no deployment difference between CUCM & CUCM session management Edition cluster. The only difference is that CUCM SME is designed to support a large number of trunk to trunk connections. Thus, 8 subscribers.
100% Leading Cisco 400-051 Questions & Answers shared by Thedumpscentre, Get HERE: http://www.thedumpscentre.com/400-051-dumps/ (New 615 Q&As)