P.S. 100% Guarantee 400-051 forum are available on Google Drive, GET MORE: https://drive.google.com/open?id=1qQLbEdau5Hd2RCxpfCKyG2vaDndDnbbq
New Questions 7
Three calls are active on ephone 1. Assume ephone 2 will remain idle.
How many additional calls can be placed from ephone 1?
A. 0
B. 1
C. 2
D. 3
E. 5
Answer: C
New Questions 8
A Call is made between two desk phones enabled with single number reach that are registered to a cisco unified CM cluster. The device pool for each device has a local route group defined. When the call is placed to exit the system, which device pool control the destination gateway?
A. Destination RDP
B. Source Phone
C. Source RDP
D. Destination phone
Answer: B
New Questions 9
Refer to the exhibit.
A user is on an outbound call through a Cisco Unified border Element gateway. When the user places the call on hold, the remote party hears silence. The Cisco Unified Communication Manager Cluster is using multicast on hold. The Cisco Unified Border Element Gateway is on the same subnet as the Cisco Unified Communication Manager Cluster.
Which two options will resolve this issue? (Choose two)
A. Media flow-through must be configured.
B. CCM-manager music-on-hold should be removed from the configuration.
C. The session transport UDP command must be configured.
D. The Cisco unified border Element router must be set up for gateway-based MOH.
E. The pass-thru content sdp command should be removed.
Answer: AE
Explanation:
Configuring the media flow-around command is required for Session Description Protocol (SDP) pass-through. When flow-around is not configured, the flow-through mode of SDP pass-through will be functional.
u2022 When the dial-peer media flow mode is asymmetrically configured, the default behavior is to fallback to SDP pass-through with flow-through.
SDP pass-through is addressed in two modes:
u2022 Flow-through-Cisco UBE plays no role in the media negotiation, it blindly terminates and re-originates the RTP packets irrespective of the content type negotiated by both the ends. This supports address hiding and NAT traversal.
u2022 Flow-around-Cisco UBE neither plays a part in media negotiation, nor does it terminate and re-originate media.
Media negotiation and media exchange is completely end-to-end.
When SDP pass-through is enabled, some of interworking that the Cisco Unified Border Element currently performs cannot be activated. These features include:
u2022 Delayed Offer to Early Offer lnterworking
u2022 Supplementary Services with triggered lnvites
u2022 DTMF lnterworking scenarios
u2022 Fax lnterworking/QoS Negotiation
u2022 Transcoding
New Questions 10
Refer to the exhibit.
How many calls, inbound and outbound combined, are supported on the lP phone?
A. 1
B. 2
C. 8
D. 12
E. 50
Answer: E
New Questions 11
Which two options are examples of data at rest? (Choose two.)
A. An email received from a colleague.
B. An email accessed via a web browser.
C. An email saved on a USB drive.
D. An email archived locally on a laptop hard drive.
E. An email sent to a colleague.
Answer: CD
New Questions 12
Refer to the exhibit.
A cisco collaboration engineer discovers that an instance of lOS media termination point (MTP) could not maintain stable registration with CUCM. Call manager traces is showing in the exhibit. What is the reason for the flapping registration?
A. The CCM version on lOS configuration does not match the CUCM version.
B. The lOS MTP is experiencing high CPU and is missing its keep-alive.
C. A Firewall is blocking port 2000 intermittently between lOS Device and CUCM.
D. Another lOS Media device is attempting to register with the same name.
Answer: D
New Questions 13
Refer to the exhibit.
A n engineer is working with globalization and has these requirements,
- The ANl to be presented in the E.164 format to the phone on Cisco unified Communications manager
- Allow redialling from the call history without manually manipulating the digit string
Which three configuration steps in Cisco unified Communications manager are needed to meet this
requirement? (Choose three).
A. set the prefix digits with 0 and calling number type subscriber
B. set the calling party transformation pattern with \+4940. And discard digits PreAt
C. set the calling party transformation pattern with \+4940. And discard digits PreDot
D. set the subscriber number prefix with +4940
E. set the prefix digits with 0 and calling number type national
F. set the national number prefix with +4940
Answer: ACD
New Questions 14
The Video engineer wants to enable the LATM codec to allow video endpoint to communicate over audio with other lP devices. Which two Characteristic should the engineer be aware of before enabling LATM on the Cisco Unified border element router? (Choose two)
A. Dual tone Multifrequency interworking with LATM codec is not supported.
B. Codec transcoding between LATM and other codecs is not supported.
C. SlP UPDATE massage outlined in RFC3311 is not supported.
D. Box-to-Box High availability support feature is not supported.
E. Configure LATM under a voice class or dial peer is not supported.
F. Basic calls using flow-around or flow-through is not supported.
Answer: AB
Explanation:
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book.pdf
New Questions 15
An engineer received this requirement from a service provider. Diversion header should match the network DlD "123456@company.com" for call Forward and transfer scenarios back to PSTN.
Which SlP profile configuration satisfies this request?
A. voice class sip-profiles 200
request lNVlTE sip-header Diversion modify "sip:(.*>)" "123456@company.com>" request RElNVlTE sipheader
Diversion modify "sip:(.*>)" "123456@company.com>"
B. voice class sip-profiles 200
request lNVlTE sdp-header Diversion modify "sip:(.*>)" 123456@company.com> request RElNVlTE sdpheader
Diversion modify "sip:(.*>)" "123456@company.com>"
C. voice class sip-profiles 200
response 200 sdp-header Diversion modify "sip:(.*>)" "123456@company.com>"
D. voice class sip-profiles 200
response 200 sip-header Diversion modify "sip:(.*>)" 123456@company.com>"
Answer: A
New Questions 16
Refer to the exhibit.
lP phone 1 has the MAC address 11111.1111.1111, while lP phone 2 has the MAC address 2222.2222.2222. The first two incoming calls were answered by lP phone 1, while the third incoming call was answered by lP phone 2.Which option describes what will happen to the fourth incoming call?
A. Both phones will ring, but only lP phone 2 can answer the call.
B. Neither phone will ring and the call will be forwarded to 2100.
C. Both phones will ring and either phone can answer the call.
D. Neither phone will ring and the call will be forwarded to 2200.
E. Both phones will ring, but only lP phone 1 can answer the call.
Answer: B
P.S. Easily pass 400-051 Exam with Dumpscollection 100% Guarantee Dumps & pdf vce, Try Free: http://www.dumpscollection.net/dumps/400-051/ (615 New Questions)