P.S. Accurate 400-101 discount pack are available on Google Drive, GET MORE: https://drive.google.com/open?id=10qRl3c2aPM7jDirL_NepQ9ytoJQZm2pM
New Cisco 400-101 Exam Dumps Collection (Question 8 - Question 17)
Q1. Which IS-IS metric style is most suitable for MPLS traffic engineering?
A. narrow
B. wide
C. transition
D. flat
Answer: A
Q2.
Refer to the exhibit After you configure the given IP SLA on a Cisco router.you note that the device is unable to fialover to the backup route even when pings to 10.12.34.5 fail.What action can you take to correct the problem?
A. Change the ip route 0.0.0.0.0.0.0.0.192.168.1.1.53.200 command to ip route 0.0.0.0.0.0.0.0 192.168.1.153.12.
B. Change the ip sla schedule 12 life forever start-time now comman to ip sla schedule 12 life forever start-time 00:12 00
C. Change the track 12 ip sla 12 state command to track 12 ip sla 12 reachability.
D. Change the frequency 2 command to frequency 12.
Answer: C
Q3.
Refer to the exhibit .Which two statements about the output are true?(Choose two)
A. BFD on RT1 has negotiated the BFD capability with its pe r
B. BFD is active on interface GigabitEthernet0/3 and is using ICMP
C. BFD is active on interface GigabitEthernet0/3 and is using UDP
D. BFD last failed 476 ms ago on interface GigabitEthernet0/3 /
E. BFD is active for BGP on RT1
Answer: D,E
Q4. Refer to the exhibit.
Switch A is connected to two MST domains for the first time. The error is observed on
Switch A %SPANTREE-2-PVSTIM_FAIL: Blocking designated port Fa0/1: Inconsistent superior PVST BPDU received onVLAN 10
How can this error be resolved?
A. Map VLAN 10 to instance 0 in all MST regions.
B. Remove the 1ST root form MST Region 2
C. Configure PVST+ to allow MST Region 1 to be root for VLAN 10
D. Map VLAN 10 into an appropriate instance on switch A
Answer: C
Q5. Which IPv4 feature prevents multicast joins on a per-port basis?
A. MLD filtering
B. IGMP filtering
C. IGMP snooping
D. PIM snooping
Answer: B
Q6.
Refer to the exhibit If R1 and R2 cannot establish an OSPF neighbor relationshipwhich two action can you take to Choose two
A. Configuration PPP authentication under the R2 Gigabitethernet 0/1 interface
B. Change the ip local pool command on R2 to ip local pool pool! 192 168 12 192 168 1.5 I"
C. Configuration R1 to send the username and password on the Dialer 1 interface
D. Change the PPP authentication to CHAP authentication
E. Configure PPP encapsulation under the R1 virtual-templat interface
Answer: C,E
Q7. Which three modes are valid for forming an EtherChannel between the ports of two switches? {Choose threE.
A. passive/passive
B. active/active
C. active/passive
D. desirable/on
E. auto/auto
F. auto/desirable
Answer: B,C,F
Q8.
Refer to the exhibit R1 is unable to ping the device at 10.3.3.3.Which two options are possible reasons for the problem?(Choose two.)
A. The static route is configured as a host route.
B. The static route points to a broadcast interface without a next-hop.
C. IP CEF is disabled on the local router.
D. Proxy ARP is disabled on the next-hop router.
E. The dynamic routing protocol configuration is missing.
F. IP CEF is disabled on the remote router
Answer: B,D
Q9. Which action enables passive interfaces in RIPv6 (RIPng)?
A. Enable passive-interface for each interface under the routing process
B. Use "passive-interface default" under the routing process
C. Passive interface are not supported in RIPng
D. Enable passive-interface on interface configuration
Answer: C
Q10. For which two conditions is Cisco Express Forwarding recursion disables by default when the BGP Prefix independent Convergence functionality is enabled? (Choose two)
A. next hops that are directly connected
B. next hops learned with any mask shorter than /32
C. next hops learned with a/32 mask
D. next hops learned with a/24 mask
Answer: A,C
Recommend!! Get the Accurate 400-101 dumps in VCE and PDF From Surepassexam, Welcome to download: https://www.surepassexam.com/400-101-exam-dumps.html (New 911 Q&As Version)