P.S. Accurate 400-101 interactive bootcamp are available on Google Drive, GET MORE: https://drive.google.com/open?id=1cF02oX7GSasuEXS-dBzgjdZ6VV4eo-Md
New Cisco 400-101 Exam Dumps Collection (Question 13 - Question 22)
Q1. Refer to the exhibit.
What is wrong with the configuration of this tunnel interface ?
A. ISATAP tunnels cannot use the EUI-64 address format.
B. The tunnel source of an ISATAP tunnel must always point to a loopback interface.
C. Router advertisements are disabled on this tunnel interface.
D. No tunnel destination has been specified.
Answer: C
Q2. In a Cisco ACL environment .which option best describes "contracts"?
A. named group of related endpoints
B. a set of interaction rules between endpoint groups
C. to determine endpoint group membership status
D. a layer 3 forwarding domain
Answer: B
Q3. Refer to the exhibit.
Which two statements about the output are true?(Choose two)
A. BFD last failed 476ms ago on interface GigabitEthernet 0/3.
B. BGP on RT1 has negotiated the BFD capability with its peer.
C. BFD is active on interface GigabitEthernet0/3 and is using ICMP.
D. BFD is active on interface GigabitEthernet0/3 and is using UDP.
E. BFD is active for BGP on RT1
Answer: B,E
Q4. Exhibit:
Refer to the exhibit. While troubleshooting an issue with a blocked switch port. you find this
error in the switch log. Which action should you take first to locate the problem?
A. Execute the show interface command to check FastEthernet 0/1
B. Check the attached switch for a BPDU filter
C. Test the link for unidirectional failures.
D. Check the attached switch for an interface configuration issue.
Answer: B
Q5. Which technology does OSPFv3 use to authenticate packets
A. SHA256
B. 3DES
C. AES
D. IPsec
Answer: D
Q6. Which option is an incorrect design consideration when deploying OSPF areas?
A. area 0 - area 2-MPLS VPN superbackbone - area 1
B. area 2 - area 0 MPLS VPN backbone - area 1
C. area 1 - MPLS VPN backbone - area 2
D. area I - area 0 - MPLS VPN backbone - area 0 - area 2
E. area 1-MPLS VPN backbone-area 1
Answer: A
Q7. Refer to the exhibit.
If you apply this configuration to a device on your network, which class map cannot match traffic?
A. CM-EXAMPLE-3
B. CM-EXAMPLE-4
C. CM-EXAMPLE-1
D. CM-EXAMPLE-5
E. CM-EXAMPLE-2
Answer: A
Q8. Which two solutions can reduce UDP latency? (Choose two)
A. low-latency queuing
B. congestion-avoidance algorithm
C. fast retransmission
D. IP service level agreements
E. fast start
F. fast recovery
Answer: A,D
Q9. Which TCP feature allows a client to request a specific packet that was lost?
A. Selective acknowledge
B. Flow control
C. Fast recovery
D. Sliding window
Answer: A
Q10. Which two statements about static routing are true?(Choose two)
A. It is highly scalable as networks grow.
B. It provides better security than dynamic routing.
C. It reduces configuration errors.
D. It requires less bandwidcth and fewer CPU cycles than dynamic routing protocols.
E. It can be implemented more quickly than dynamic routing.
Answer: B,D
P.S. Easily pass 400-101 Exam with Allfreedumps Accurate Dumps & pdf vce, Try Free: https://www.allfreedumps.com/400-101-dumps.html (911 New Questions)