Updated Cisco 400-201 exam questions and 400-201 braindumps from Dumpslabs.com. Pass the CCIE Service Provider 400-201 exam with our 400-201 VCE dumps. Start 400-201 Exam Now.
2024 Cisco Official New Released 400-201 Q&As
100% Free Download! 100% Pass Guaranteed!
https://www.certleader.com/400-201-dumps.html
Q1. Which two statements about forwarding equivalence class (FEC) are true? (Choose two) A. FEC might correspond to a destination IP subnet, but it might also correspond to any traffic class that the edge LSR considers significant. B. FEC is a group of IP packets that is forwarded over a different path, but with the same forwarding treatment. C. FEC is a group of IP packets that is forwarded o
Q1. Based on the following configuration: Which two statements about multicast VPN configuration are true? (Choose two.) A. The multicast tree is created based only on the existence of active sources or receivers behind PEs in the ABC VRF. B. The service provider core network is required to support SSM. C. Multicast needs to be enabled only on ABC VRF and is tunneled to participating PE route
Q1. Which are the three header fields that affect how Equal-Cost Multipath hashes traffic flow into interface groups? (Choose three.) A. source MAC address B. source port C. source IP address D. destination IP address E. IP protocol ID F. destination MAC address View AnswerAnswer: B,C,D Explanation: https://supportforums.cisco.com/document/111291/asr9000xr-loadbalancing-architecture-and-
Q1. Refer to the exhibit. The NOC engineer noticed that the R2 router system clock is not updated and synchronized to the NTP server that is configured on the R10 router. What is the issue? A. The access list NTP_Clients is missing. B. The access group is misconfigured. C. The maximum number of peers and client associations is exceeded. D. The authentication key is mismatched. E. The PE2 ro
Q1. What are three actions that the control word performs in MPLS AToM? (Choose three.) A. is used to identify the VC label B. is used for padding small packets C. preserves the sequence of the transported frames D. facilitates the load balancing of AToM packets in the MPLS backbone network E. carries control bits of the Layer 3 header of the transported protocol F. is used to identify the
Q1. Refer to the exhibit. A web server is connected to a switch via two Gigabit Ethernet links. These two links are bundled into a single logical link that provides the aggregate bandwidth of 2 Gbps. The support engineer notices that traffic from the Internet to the web server uses both Gigabit Ethernet links. However, traffic from the web server to the Internet uses only one link. Which CLI com
Q1. Refer to the exhibit. A company has a requirement to provide communication among remote sites via multipoint GRE tunnels. This communication is not working yet. Which is the root cause of this issue? A. The key that is used on the DMVPN tunnel between the spoke and hub ends does not match. This causes the tunnel to fail. B. BGP IPv4 multicast address-family is missing between hub and spoke
Q1. Which are the three characteristics of SDR? (Choose three) A. The logical router can span across chassis. B. Each logical router has a distinct fabric and system controller module. C. Owner SDR can be reloaded, without affecting all non-SDRs. D. The logical router has dedicated route processor. E. The logical router can share line cards. F. The fabric and system controller module are sh
Q1. Refer to the exhibit. Which statement is true? A. This is an inter autonomous unicast route. B. The BGP MED value is 26. C. This is an mVPN route. D. The route target value is 10.1.100.2:3. E. There is a route reflector in this network. F. The route did not import this route into the VRF one. View AnswerAnswer: E Q2. How many bits are expressed by";:" in the address 2D01:DB::C:B7BA:
Q1. A network engineer needs to connect two core switches that use Gigabit Ethernet interfaces in an MPLS backbone and that are separated by a distance of 60 km. Which Cisco GBIC achieves this goal? A. Cisco 1000BASE-T GBIC B. Cisco 1000BASE-SX GBIC C. Cisco 1000BASE-LX/LH GBIC D. Cisco 1000BASE-ZX GBIC View AnswerAnswer: D Explanation: http://www.cisco.com/web/partners/downloads/765/tool
Q1. Refer to the exhibit. Why does R1 not receive a label for 10.0.0.3/32 prefix? A. R1 does not have an established LDP neighborship with the router announcing the 10.0.0.3/32 prefix. B. The 10.0.0.3/32 prefix is being null-routed in the downstream neighbor C. LDP peer is not configured to advertise a label for the 10.0.0.3/32 prefix D. BGP is not configured to exchange labels with the BGP