Q1. What is the dotted hexadecimal representation of the IP address 172.13.99.225?
A. AC.0D.63.E1
B. AB.63.99.D5
C. E2.1D.E1.66
D. BC.0C.C3.1F
E. CC.0D.F3.21
Answer: A
Q2. What action does a switch take if the destination MAC address is unknown?
A. discard frame
B. send ICMP unreachable message to source
C. flood packet on all ports
D. compare destination IP address against an ACL to determine if it is permitted
E. send gratuitous ARP on all ports and wait for reply before forwarding
Answer: C
Q3. Which VTP mode disallows the creation of local VLANs?
A. transparent
B. tunneling
C. server
D. client
E. off
F. native
Answer: D
Q4. Which option is an example of a link-state routing protocol?
A. EIGRP
B. RIP
C. OSPF
D. ARP
Answer: C
Q5. On a new Cisco Nexus switch, you receive an error message when you attempt to create an SVI. What is the first command you must use to create the SVI?
A. interface vlan (vlan_id)
B. vlan (vlan_id)
C. feature svi
D. interface routed
Answer: C
Q6. Which two layers of the OSI model are combined in the Internet protocol suite network access layer? (Choose two.)
A. 1
B. 2
C. 3
D. 4
E. 5
F. 6
G. 7
Answer: AB
Q7. Which two statements describe the purpose of RFC 1918? (Choose two.)
A. Establish a range of IP addresses that are dedicated to the growing use of multicast video.
B. Establish a range of IP addresses that are dedicated to the growing use of peer-to-peer file-sharing applications.
C. Establish a range of IP addresses that are dedicated to use on internal networks.
D. Establish a range of IP addresses to address the shrinking pool of globally routable addresses.
E. Delay the transition to IPv6.
Answer: CD
Q8. Which network topology is most closely associated with FDDI?
A. bus
B. token passing bus
C. star
D. extended star
E. ring
Answer: E
Q9. Which command should you use to configure a Cisco Nexus switch port for Layer 2 operation?
A. nexus(config-if)#switchport
B. nexus(config-if)#layer-2
C. nexus(config-if)#routed
D. nexus(config)#interface vlan 10 nexus(config-if)#switchport
Answer: A
Q10. Which three terms are used to describe data at Layers 1, 2, and 4 of the OSI model? (Choose three.)
A. PDUs
B. bits
C. sequences
D. segments
E. packets
F. frames
Answer: BDF