Q1. Cisco VM-FEX technology extends Cisco Fabric Extender technology to the virtual machine that eliminates which one of the following?
A.The dedicated interface on the parent switch is eliminated.
B.The software-based switch in the hypervisor is eliminated.
C.All virtual machine traffic is eliminated.
D.The need for a physical switch is eliminated.
Answer: B
Q2. Which Cisco Nexus product operates inside the VMware ESX hypervisor, and supports the Cisco VM-FEX server virtualization technology?
A.1010
B.2000
C.5500
D.7000
Answer: A
Q3. Which four statements about Cisco Overlay Transport Virtualization are true? (Choose four.)
A.OTV is a "MAC in IP" technique for supporting Layer 2 VLANs over any transport.
B.OTV is not a public standard, even though the technology is based on standardized protocols.
C.OTV is public standard because the technology is based on standardized protocols.
D.OTV is supported on all M-Series modules of Cisco Nexus 7000.
E.OTV is core and site transparent. Changes to the Layer 2 design of the sites are needed.
F.OTV enables the network administrator to statically map MAC addresses to IP addresses.
G.OTV cannot support multiple concurrent overlays.
H.OTV supports Catalyst 6500.
Answer: ABDF
Q4. What is a typical output of the design planning phase that characterizes an existing data center?
A.a high-level conceptual architecture proposal
B.a gap analysis
C.a verification plan
D.reactive fault detection and correction
Answer: B
Q5. Given the requirements, which Cisco Nexus product is Cisco recommended?
A rich feature set that makes it well suited to top-of-rack, middle-of-row, or end-of-row access-layer applications.
Data center racks with standards-based 1 and 10 Gigabit Ethernet and FCoE features, and virtual machine awareness features that allow IT departments to consolidate networks.
A combination of high port density, lossless Ethernet, wire-speed performance, and extremely low latency that makes the switch family well suited to meet the growing demand for 10 Gigabit Ethernet.
A.1000v
B.1010
C.2000
D.3000
E.4000
F.5500
Answer: F
Q6. Which is a feature of the Data Center Core layer?
A.The core layer provides the high-speed packet switching backplane for all flows going in and out of the data center.
B.The core layer provides the high-speed packet switching backplane for all flows going out of the data center.
C.The core layer is purely a Layer 2 environment. As a result, the core layer is not free of spanning tree and vPC.
D.The core layer provides connectivity to multiple aggregation modules and provides a resilient Layer 3 routed fabric with a single point of failure.
Answer: A
Q7. In a medium size Data Center, which three routing protocols would you use? (Choose Three.)
A.EIGRP
B.ISIS
C.OSPF
D.RIPv2
E.HSRP
Answer: ABC
Q8. When designing a data center environment with ECMP and IP routing between the data center network segments, which design would be the most suitable?
A.Layer 3 data center core
B.Layer 3 data center core with Layer 2 extension
C.Layer 2 data center core
D.Layer 2 data center core with Layer 3 extension
Answer: A
Q9. Which two options are business requirements that drive the data center design? (Choose two.)
A.Increase virtual machine-to-host ratio.
B.Reduce power consumption.
C.Reduce latency within the network.
D.Migrate to FCoE.
E.Reduce operation expenditure.
F.Increase network throughput.
Answer: BE
Q10. Which two Cisco MDS 9500 line cards support SME? (Choose two.)
A.Cisco MDS 9000 Family Storage Services Module
B.Cisco MDS 9000 Family Multiprotocol Services Module
C.Cisco MDS 9000 Family 8-Gbps Advanced Fibre Channel Switching Module
D.Cisco MDS 9000 Family IP Storage Services Module
E.Cisco MDS 9000 Family Storage Processor Node
F.Cisco MDS 9000 Family Multiservices Module
Answer: BF