Q1. Which two issues explain why a packet is not being routed as desired in a policy-based routing configuration? (Choose two.)
A. The route map is not applied to the egress interface.
B. The route map is not applied to the ingress interface.
C. The next hop that is configured in the route map is not in the global routing table.
D. The next hop that is configured in the route map has a higher metric than the default next hop.
Answer: CD
Q2. Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Q3. Which statement about scalability in Cisco OTV is true?
A. The control plane avoids flooding by exchanging MAC reachability.
B. IP-based functionality provides Layer 3 extension over any transport.
C. Any encapsulation overhead is avoided by using IS-IS.
D. Unknown unicasts are handled by the authoritative edge device.
Answer: A
Q4. Which two Cisco Nexus platforms support Adapter FEX? (Choose two.)
A. Cisco Nexus 7000 Series Switches
B. Cisco Nexus 5000 Series Switches
C. Cisco Nexus 5500 Series Switches
D. Cisco Nexus 4000 Series Switches
E. Cisco Nexus 2000 Series Fabric Extenders
Answer: CE
Q5.
What is the status of FC interface associated with ethernet 1/5 indicate?
A. Trunk VSAN 11 is isolated B. Inteface vfc 5 is up and running for the assigned VSAN
C. Trunk VSAN 11 is intializing
D. VSAN to FC mapping is not working as expected
Answer: B
Q6. What configuration is required when implementing FCoE?
A. disable LAN traffic on the interface
B. configure PortFast on the access port
C. permit all VLANs on the interface
D. permit all VSANs on the interface
Answer: A
Q7. How does an FCoE end node acquire its FCoE MAC address?
A. server-provided MAC address
B. Fibre Channel name server
C. fabric-provided MAC address
D. FIP proxy
Answer: C
Q8. Which two statements about SAN zoning on Cisco Nexus switches are true? (Choose two.)
A. Unlike configured zones, default zone information is not distributed to the other switches in the fabric.
B. Traffic can either be permitted or denied among members of the default zone. This information is not distributed to all switches. It must be configured in each switch.
C. The settings for default zone configurations cannot be changed.
D. To activate a zone set, you must copy the running configuration to the startup configuration after the zone set is configured.
E. Soft zoning restrictions will not prevent a source device from accessing a device outside its zone, if the source knows the Fibre Channel ID of the destination.
F. Hard zoning is enforced by the hardware on each FLOGI sent by an N Port.
Answer: BE