Q1. - (Topic 7)
Which antivirus inspection mode must be used to scan SMTP, FTP, POP3 and SMB protocols?
A. Proxy-based.
B. DNS-based.
C. Flow-based.
D. Man-in-the-middle.
Answer: C
Q2. - (Topic 15)
Which statement is an advantage of using a hub and spoke IPsec VPN configuration
instead of a fully-meshed set of IPsec tunnels?
A. Using a hub and spoke topology provides full redundancy.
B. Using a hub and spoke topology requires fewer tunnels.
C. Using a hub and spoke topology uses stronger encryption protocols.
D. Using a hub and spoke topology requires more routes.
Answer: B
Q3. - (Topic 15)
Review the IKE debug output for IPsec shown in the exhibit below.
Which statements is correct regarding this output?
A. The output is a phase 1 negotiation.
B. The output is a phase 2 negotiation.
C. The output captures the dead peer detection messages.
D. The output captures the dead gateway detection packets.
Answer: C
Q4. - (Topic 15)
Review the static route configuration for IPsec shown in the exhibit; then answer the question below.
Which statements are correct regarding this configuration? (Choose two.)
A. Interface remote is an IPsec interface.
B. A gateway address is not required because the interface is a point-to-point connection.
C. A gateway address is not required because the default route is used.
D. Interface remote is a zone.
Answer: A,B
Q5. - (Topic 2)
What logging options are supported on a FortiGate unit? (Choose two.)
A. LDAP
B. Syslog
C. FortiAnalyzer
D. SNMP
Answer: B,C
Q6. - (Topic 14)
The exhibit shows the Disconnect Cluster Member command in a FortiGate unit that is part of a HA cluster with two HA members.
What is the effect of the Disconnect Cluster Member command as given in the exhibit. (Choose two.)
A. Port3 is configured with an IP address for management access.
B. The firewall rules are purged on the disconnected unit.
C. The HA mode changes to standalone.
D. The system hostname is set to the unit serial number.
Answer: A,C