Q1. - (Topic 6)
You are the administrator in charge of a FortiGate acting as an IPsec VPN gateway using route-based mode. Users from either side must be able to initiate new sessions. There is only 1 subnet at either end and the FortiGate already has a default route.
Which two configuration steps are required to achieve these objectives? (Choose two.)
A. Create one firewall policy.
B. Create two firewall policies.
C. Add a route to the remote subnet.
D. Add two IPsec phases 2.
Answer: B,C
Q2. - (Topic 15)
Review the IPsec diagnostics output of the command diagnose vpn tunnel list shown in the exhibit below.
Which statements are correct regarding this output? (Choose two.)
A. The connecting client has been allocated address 172.20.1.1.
B. In the Phase 1 settings, dead peer detection is enabled.
C. The tunnel is idle.
D. The connecting client has been allocated address 10.200.3.1.
Answer: A,B
Q3. - (Topic 12)
A FortiGate is operating in NAT/Route mode and configured with two virtual LAN (VLAN) sub-interfaces added to the same physical interface.
Which one of the following statements is correct regarding the VLAN IDs in this scenario?
A. The two VLAN sub-interfaces can have the same VLAN ID only if they have IP addresses in different subnets.
B. The two VLAN sub-interfaces must have different VLAN IDs.
C. The two VLAN sub-interfaces can have the same VLAN ID only if they belong to different VDOMs.
D. The two VLAN sub-interfaces can have the same VLAN ID if they are connected to different L2 IEEE 802.1Q compliant switches.
Answer: B
Q4. - (Topic 22)
Two FortiGate units with NP6 processors form an active-active cluster. The cluster is doing security profile (UTM) inspection over all the user traffic. What statements are true regarding the sessions that the master unit is offloading to the slave unit for inspection? (Choose two.)
A. They are accelerated by hardware in the master unit.
B. They are not accelerated by hardware in the master unit.
C. They are accelerated by hardware in the slave unit.
D. They are not accelerated by hardware in the slave unit.
Answer: A,D
Q5. - (Topic 5)
Regarding tunnel-mode SSL VPN, which three statements are correct? (Choose three.)
A. Split tunneling is supported.
B. It requires the installation of a VPN client.
C. It requires the use of an Internet browser.
D. It does not support traffic from third-party network applications.
E. An SSL VPN IP address is dynamically assigned to the client by the FortiGate unit.
Answer: A,B,E
Q6. - (Topic 4)
The FortiGate port1 is connected to the Internet. The FortiGate port2 is connected to the internal network. Examine the firewall configuration shown in the exhibit; then answer the question below.
Based on the firewall configuration illustrated in the exhibit, which statement is correct?
A. A user that has not authenticated can access the Internet using any protocol that does not trigger an authentication challenge.
B. A user that has not authenticated can access the Internet using any protocol except HTTP, HTTPS, Telnet, and FTP.
C. A user must authenticate using the HTTP, HTTPS, SSH, FTP, or Telnet protocol before they can access all Internet services.
D. DNS Internet access is always allowed, even for users that has not authenticated.
Answer: D
Q7. - (Topic 3)
Which firewall objects can be included in the Destination Address field of a firewall policy? (Choose three.)
A. IP address pool.
B. Virtual IP address.
C. IP address.
D. IP address group.
E. MAC address.
Answer: B,C,D
Q8. - (Topic 18)
Which tasks fall under the responsibility of the SSL proxy in a typical HTTPS connection? (Choose two.)
A. The web client SSL handshake.
B. The web server SSL handshake.
C. File buffering.
D. Communication with the URL filter process.
Answer: A,B
Q9. - (Topic 4)
Which statement regarding the firewall policy authentication timeout is true?
A. It is an idle timeout. The FortiGate considers a user to be “idle” if it does not see any packets coming from the user’s source IP.
B. It is a hard timeout. The FortiGate removes the temporary policy for a user’s source IP address after this timer has expired.
C. It is an idle timeout. The FortiGate considers a user to be “idle” if it does not see any packets coming from the user’s source MAC.
D. It is a hard timeout. The FortiGate removes the temporary policy for a user’s source MAC address after this timer has expired.
Answer: A
Q10. - (Topic 14)
What are the requirements for a HA cluster to maintain TCP connections after device or link failover? (Choose two.)
A. Enable session pick-up.
B. Enable override.
C. Connections must be UDP or ICMP.
D. Connections must not be handled by a proxy.
Answer: A,D